Sharpening and changing
blade
Blade should always be
sharpened by an approved
Service Centre. Change
blade according to drawing.
Replacement blade available as
accessory. Part no. 6155 400.
Gloves should beworn at all timeswhenworking on the
blade. Remove ignition key and spark plug lead when
working on the blade.
Information forService Centre:
Blade retaining screwto be tightened to 50–55Nm.
Cleaning of air filter
- Remove lid of filter housing.
- Remove foam filter element.
- Thoroughly wash the filter in water or a soap solution.
Never lubricate the filter.
- squeeze dry,
Maintenance
Observe following maintenance procedure to ensure lasting
trouble-free mowing with your Scooter,
* Important: brakes should only be adjusted or serviced by an
approved Service Centre.
If working under extreme conditions or higher temperatures shor-
ter service intervals may be necessary than in the table above.
Maintenance
- Clean inside of filter housing.
- Remove dirt from paper filter by shaking. Check paper
filter – replace if damaged in any way.
Take care paper lter does not come into contact with oil.
Winter storage
• Drain fuel tank.
• Drain carburettor by letting engine run until it runs out
of fuel.
• Clean Cart thoroughly.
• Change oil.
• Prepare engine for winter storage as follows:
• Remove spark plug
• Pour one spoonful of engine oil into spark plug hole
• Pull starter rope slowly to distribute oil evenly inside
cylinder.
• Replace spark plug but do not connect spark plug lead
• Pull starter rope until resistance is felt.
We recommend: Have your Cart thoroughly checked
once a year by an approved Service Centre.