638167
12
Zoom out
Zoom in
Previous page
1/34
Next page
12
G
Safety instructions
Meaning of the symbols
General Notes
z This lawnmower is intended for the care of grass and lawn
areas in private grounds. Because of physical danger to the
operator or other persons, the lawnmower must not be used
for other purposes.
z Do not mow the grass if persons, especially children and ani-
mals, are in the vicinity.
z Only mow the grass if the light conditions are suitable.
Before mowing
z Only mow the grass wearing sturdy shoes and long trousers.
z Never mow the grass in bare feet or wearing sandals.
z Check the ground where the lawnmower is to be used, and re-
move any items which could be picked up and thrown out by
the lawnmower.
z Check the connection cable and the wire fitted to the outside
of the mower for damage and ageing (brittleness). Use only if
it is in perfect condition.
z Check the grass collection unit regularly for wear and defor-
mation.
z Before use check (visually), whether the cutting tools and their
fixings are blunt or damaged.
z Replace the cutting tools if they are blunt or damaged in comple-
te sets to avoid imbalance (see „Maintenance“, page 14).
Cable
1 Caution! Risk of electrocution from damaged cables
The fuse does not always respond if the cable is cut
or damaged.
z Do not touch the cable before the plug has been remo-
ved from the plug socket.
z Damaged cables should be replaced completelyIt is pro-
hibited to mend the cable using insulating tape.
z Repairs to the cable should only be undertaken by an expert
(see „Faults and how to remedy“, page 15).
z Attach the cable to the tension relief unit. Do not let it rub up
against edges, points or sharp items.
z Do not squash the cable by putting it through door gaps or
gaps in windows.
z Switching devices must not be removed or bridged out
(e.g.strapping the switching lever to the guide bar).
z Use only extension cables with a minimum cross-section of
3x1.5mm
2
and a length of max. 25 m:
When using rubber-sheathed cables, they must be of
type HO 7 RN-F or heavier.
When using PVC-sheathed cables, they must be of type
HO5 VV-F or heavier (cables of this type are not suitable for
continuous outdoor use -
e.g. underground installation for the
connection of an outdoor socket or pond pump, or outdoor storage).
z The cables must be water spray protected.
When mowing
z
Do not tilt the mower when starting the motor unless it has to be
tilted when starting. In this case, do not tilt it more than neces-
sary and only lift the section that is away from the opera-
tor.Check continuously that both hands are in the working
position before lowering the mower back to the ground.
z Keep the distance away provided by the handle linkage.
z Only switch the motor on if your feet are at a safe distance
from the cutting tools.
z Ensure that it is standing securely.Never run, move for-
wards smoothly.
z Mowing on inclines:
Always mow at right angles to the incline, not up and down
Take particular care when changing direction.
Do not mow very steep ground
z Take particular care when mowing backwards and pulling the
mower towards you.
z Switch the mower off when tilting or transporting it, e.g. from/to
the lawn or over paths.
z Take care not to grab running cutters.
z Do not stand in front of the grass ejection opening.
z Before lifting or carrying the mower, switch the motor off and
wait until the cutting tools have come to a standstill.
z Only adjust the cutting height with the motor switched off and
with the cutting tools at a standstill.
z Never open the protective cover if the motor is still running.
z Before removing the grass collection device:Switch the motor
off and wait until the cutting tools come to a standstill.After
emptying, fix the grass collection device carefully.
z Never run the mower over gravel– Stones will fly up!
z If possible, do not mow if the grass is wet.
z Under the following conditions the mower must be switched
off, the mains plug must be removed and the mower must
be stationary:
when leaving the mower
when releasing blocked cutters
in order to check the mower, to clean it and to work on it
if foreign bodies are struck (check first whether the mower
or cutting tools have been damaged. Only then should you
remove the damage).
if the mower is vibrating badly because of imbalance (switch
off and look for the cause).
if the connection wire is damaged during use.
Attention!
Read instruction
manual before
use!
Keep bystan-
ders away!
Attention!
- Sharp knives -
before perfor-
ming a mainte-
nance work or if
the cable is da-
maged pull out
the plug!
Keep the sup-
ply flexible cord
away from the
cutting blade!
0054659.book Seite 12 Mittwoch, 8. April 2009 12:00 12
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for WOLF-Garten Power Wolf 16-40 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of WOLF-Garten Power Wolf 16-40 in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 3,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info