484179
14
Zoom out
Zoom in
Previous page
1/38
Next page
Operation
Assembly
Fixing of handle
A
B
C
ATTENTION! Take care that theswitch cable does not become
caught and crused when folding the handle frame.
1. Fold the handle bar toward the back (A).
2. Set the handle to the desired height and tighten the two
wing nuts (B).
3. Fold the upper handle up and screw it tight with the two
wing nuts (C).
Safety instructions
• Do not leave the mower in closed areas after switching off -
allow it to cool off in the open air before storing away.
• Never keep the machine with petrol in the tank within a building
in which gasoline vapours may possibly come into contact with
naked ames or sparks. Before leaving the mower remove the
spark plug lead and - if tted - the starting key.
• Lifting and carrying the mower for transport:
Never attempt to lift the mower with the engine running - nor with
a hot engine - always remove the spark plug lead before lifting or
carrying.
• When folding the mower handlebars, detach starter rope
and make certain that the control cables are not snagged or
stretched when folding or unfolding.
• Always carry out the engine oil change with the fuel tank empty
and ller cap tted. The engine should be warmed up prior to
draining the oil to ensure all sludge deposits are drained away
with the oil.
Maintenance
• Regularly examine all xing bolts and nuts, particularly those of
the cutter bar, for tightness.
Maintenance and cleaning of the equipment as well as remov-
ing the protection device may only be performed with the engine
stopped and the spark plug lead and - if available - the starting
key, removed.
Note information on the chassis before cleaning and oil change!
• Make certain that all nuts, pins and screws are rmly tightened
and that the unit is in a safe operating condition.
• In order to avoid the risk of re keep the engine, exhaust, bat-
tery box and the area around the fuel tank free of grass, leaves
or oil.
• If the equipment must be tilted for maintenance work then the
fuel must be completely drained from the tank beforehand.
• Clean the equipment after each use with a hand-brush - not
with water and do not hose down with a high pressure hose
in particular. Make certain to keep the engine cooling ns and
engine cooling air intake clean and free from debris.
• Do not place the equipment in damp areas, near naked ames
or where a spark might ignite petrol vapour.
• If the fuel tank is to be emptied then this should be done out-
doors. Make sure that no fuel is spilled.
• For safety reasons replace worn out or damaged parts.
• NOTE! Always have blades replaced or sharpened by a WOLF
Service Centre, as a blade balance test must be performed in
accordance with safety regulations and the blade retaining bolt
must be tightened to a specied torque.
• Wear suitable work gloves when carrying out the above work,
especially when handling the blade.
14
Emptying the grass bag
R
Only when mower is stationary and rotating blade
has come to complete standstill.
When the grass bag is full, the ap lowers automatically.
To ensure proper functioning: clean the holes beneath
the level indicator in the grass bag regularly with a hand
brush.
Inserting the mulching kit
Make sure that the motor is switched off
and the cutting blade is not moving.
1. Remove the grass bag.
2. Assemble as shown in illustrations
F
G
3. Disassemble as shown in illustrations
H
J
MulchingMowing
Hanging the grass bag
N
Only when mower is stationary and rotating blade
has come to complete standstill.
1. Lift the protective ap.
2. Hang the grass bag in the chassis with the hooks in the
recesses (see arrow).
3. Replace the protective ap
„Mulching“ is a process in which the grass is nely chop-
ped by a special cutting system and then deposited on the
ground. The result is that the grass does not have to be
collected and disposed of. „Mulching“ also prevents the lawn
from drying out.
Note:
• Depending on how fast the grass grows, you should mulch
1-2 times each week.
• The grass should not be too high or very wet!
• Walk slowly.
• When cutting, the strips should overlap.
• Do not cut more than 20 cm of grass at a time.
Important!
„Mulching“ is not recommended if the lawn is mossy or
matted.
Reason:
The cut grass remains on top fo the moss or matted grass
and cannot reach the ground below.
Remedy:
The lawn should be aerated and fertilized regularly.
Mount grass catcher
D
E
See illustrations.
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for WOLF-Garten Power Edition 40 TMA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of WOLF-Garten Power Edition 40 TMA in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 1,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info