484181

WOLF-Garten Power Edition 40 KA Manual

15
Zoom out
Zoom in
Previous page
1/38
Next page
Operation
Switching wheel drive on/off
K
(Power Edition 40/46 KA)
Wheel drive on:
Lift drive bar (3).
Wheel drive off:
Release drive bar (3).
Selecting the speed (Vario)
1. Press button (4)
2. Use the lever (5) to select the desired working speed
(2.5 km/h - 5.0 km/h).
Rabbit: faster. Snail: slower.
15
Operating times
Please check noise abatement regulations prevailing in your
country.
Starter cord assembly
K
L
1. Press red button (K, 1) and keep it depressed.
2. Lift and hold operator presence bail arm (K, 2).
3. Pull the starter rope slowly to the holding bracket.
4. Twist the cord through the holder (L).
Always remove the starter cord from the holder before
folding the mower handles.
Oil Fill
M
Check oil level regulary before mowing!
To check, do not screw in the dipstick.
Fill crankcase with quality oil SAE 30 up to the marking „Full“
on dipstick.Capacity approx. 0,6 litre . Lift mower slightly on
the oil filter side whilst pouring oil slowly.
Filling with Petrol
Do not smoke - no naked flames!
Switch off engine.
Avoid spilling petrol when engine is warm.
Use „low-octane petrol“ (do not use Super Plus).
Avoid petrol spillage.
Do not inhale vapour.
Use of height adjustment
O
Only when mower is stationary and rotating blade
has come to complete standstill.
Place hand into handle bar and depress button (1). Lift or
lower chassis until it engages into required position (2).
Tips for mowing
P
• To prevent strips of grass from being left unmowed, the
cutting paths must always overlap a few centimeters.
• Always turn the mower on a surface that has already been
mowed.
Start
K
L
• On a at surface, if possible not in high grass.
Cold start
1. Set hand throttle (K, 1) on start.
2. Raise and hold the safety bracket (K, 2). Pull starter grip
(L) and return it slowly by hand.
3.
After starting, slowly move the hand throttle to “Operate”.
Maintenance
Disconnect spark plug cap and starter key before
proceeding
Clean mower thoroughly after each mowing with cloth or
brush.
Do not spray with water. Keep mower in a dry room.
Cleaning operations and blade change
R
1. Pull off the sparkplug connector!
2. Raise the cutting height to its highest position
3. For cleaning work and blade replacement tilt the mower back
as shown in the illustration.
Change of Cutter blades
S
Disconnect spark plug cap and starter key before
proceeding
• Change of blades only be carried out by an approved
service station.
•
Gloves should be worn at all times when working on the
blade. Remove ignition key and spark plug lead when
working on the blade.
• Damaged blades should always be replaced in pairs to
ensure even balance.
I
nformation for Service Centre, blade retaining screw to be
tightened to:
A/F 17 mm = 38-42 Nm / A/F 13 mm = 16-20 Nm
Adjusting the Bowden cable coupling
K
T
1. Raise the drive bracket (K, 3) app. 2 cm and hold.
2. Loosen the locking nut (T, 1).
3. Turn the setscrew (T, 2) left until the drive wheels are
blocked when you pull the mower backwards.
4. Tighten locking nut (T, 1).
Change oil only
While engine is warm and fuel tank empty.
Change oil after the first 5 working hours. Thereafter change
engine oil every 25 working hours and at the end of the
mowing season. Change engine oil more frequently if working
under extreme and dusty conditions. To drain the engine oil,
remove oil filler cap, tilt machine slowly to side and allow oil to
drain from the crankcase through the filler.
Oil Fill
M
Cleaning of Spark Plug
Check and clean regularly, reset plug gap as required (0,70 mm).
If possible, mow when grass is dry in order to protect turf.
Do not set cutting position too low when mowing very tall or wet
grass. We recommend an average cutting height of 4,0 - 5,0 cm.
Cleaning the air filter
U
V
W
Clean pre-filter after every 25 hours of operation and paper
filter inserts yearly or after every 100 hours of operation.
1. Open cover as shown in illustration.
2. Remove pre-filter (a) and paper insert (b).
2. Wash pre-filter (a) in a non-caustic cleaning solution and allow
to dry thoroughly.
3. Beat dust out of paper insert (b) carefully. Very dirty or
damaged inserts must be replaced. Do not wash out paper
insert or blow out with compressed air.
Do not oil pre-filter and paper insert!
4. After maintenance, re-insert pre-filter and paper insert as
shown in illustration.
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for WOLF-Garten Power Edition 40 KA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of WOLF-Garten Power Edition 40 KA in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 1,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info