638137
15
Zoom out
Zoom in
Previous page
1/38
Next page
14
15
Maintenance
Cleaning operations and blade change
S
1. Pull off the sparkplug connector!
2. Raise the cutting height to its highest position
3. For cleaning work and blade replacement tilt the mower back
as shown in the illustration.
Change of Cutter blades
U
Disconnect spark plug cap and starter key before
proceeding
Change of blades only be carried out by an approved
service station.
Gloves should be worn at all times when working on the
blade. Remove ignition key and spark plug lead when
working on the blade.
Damaged blades should always be replaced in pairs to
ensure even balance.
I
nformation for Service Centre, blade retaining screw to be
tightened to:
A/F 17 mm = 38-42 Nm / A/F 13 mm = 16-20 Nm
Adjusting the Bowden cable coupling
K
V
1. Raise the drive bracket (K, 3) app. 2 cm and hold.
2. Loosen the locking nut (T, 1).
3. Turn the setscrew (T, 2) left until the drive wheels are
blocked when you pull the mower backwards.
4. Tighten locking nut (T, 1).
Change oil only
While engine is warm and fuel tank empty.
Change oil after the first 5 working hours. Thereafter change
engine oil every 25 working hours and at the end of the mowing
season. Change engine oil more frequently if working under
extreme and dusty conditions. To drain the engine oil, remove
oil filler cap, tilt machine slowly to side and allow oil to drain
from the crankcase through the filler.
Oil Fill
M
Cleaning of Spark Plug
Check and clean regularly, reset plug gap as required (0,70 mm).
Cleaning of air filter
Refer to the engine manufacturer‘s handbook supplied.
Winter storage
Drain fuel tank.
Drain carburettor
- start engine, keep it running until it stops from fuel
Starvation
Clean the whole machine thoroughly
Change oil, 4-stroke engine.
Prepare engine for winter storage as follows:
- Remove spark plug
- Poor one teaspoon full of engine oil into spark plug hole
-
Pull starter rope slowly to distribute oil evenly inside cylinder
- Replace spark plug but do not connect spark plug lead
-
Pull starter rope until resistance is felt (valves are now closed)
Store mower in a cool and dry place.
We recommend: Have your mower thoroughly checked once
a year by approved Service Agent.
Remedy (X) by:
Problem Possible cause
WOLF
service-workshop
Yourself
Motor does not start or has
no power:
• Insufcient fuel in the tank
• Spark plug lead not connected
• Spark plug out of order
• Air lter dirty or oily
• Throttle lever not at „Run“
• Blade fastening screw loose
---
---
---
---
---
X
X
X
X
X
X
---
Uneven cutting:
• Cutting height misadjusted
• Blunt blades
• Air / duct catcher bag blocked
---
X
---
X
---
X
Drive does not start: • Clutch Bowden cable misadjusted --- X
When in doubt, always consult a WOLF service workshop. Important: switch off the mower and disconnect the spark plug
lead before inspecting, cleaning or working on the blades.
Faults and how to remedy
Cleaning
Note: Disconnect electricity by unplugging cable
at the socket before proceeding. Attention: Keep
hands clear of moving blade.
Clean mower thoroughly after each mowing with cloth or
brush.
Clean the mulch flap at regular intervals with a small broom
T
.
Do not spray with water.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for WOLF-Garten Power Edition 40 H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of WOLF-Garten Power Edition 40 H in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 3,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info