457594
12
Zoom out
Zoom in
Previous page
1/110
Next page
12
G
When using PVC-sheathed cables, they must be of type
HO5 VV-F or heavier (cables of this type are not suitable for
continuous outdoor use -
e.g. underground installation for the
connection of an outdoor socket or pond pump, or outdoor storage).
z Plugs and couplings must be protected from splashes.
z Use a residual current protection device (RCD) with a residual
current not exceeding 30 mA.
z Fit the connection cable to the mains lead cleat. Do not allow
to rub against edges or against sharp or pointed objects. Do
not squeeze cables through tight door or window openings.
Switch devices must not be removed or circumvented (e.g.
connecting the switch lever to the handle bars)
When mowing
z Do not tilt the lawnmower when switching on the motor, unless
the lawnmower has to be tilted when starting. If that is the
case, do not tip the lawnmower more than absolutely neces-
sary, and only lift the part furthest removed from the user. Al-
ways ensure that both hands are in the operating position
before replacing the lawnmower on the ground.
z Caution, danger! Cutting gear will continue running!
z Maintain the safety distance prescribed by the handle bars.
z Only switch on the motor if your feet are at a safe distance
from the cutting gear.
z Take care to ensure a safe and stable position, especially on
slopes. Never run; always walk calmly forward.
z Always mow slopes at right angles to the incline; never mow
up and down.
z When mowing slopes, be especially careful when changing di-
rection.
z Never mow steep slopes.
z Be especially careful when mowing backwards and pulling the
lawnmower towards you.
z Switch the mower off when tilting it, running on empty or trans-
porting the lawnmower, e.g. to/from a lawn or along paths.
z Never use the lawnmower if safety devices are faulty or mis-
sing, such as deflector and/or grass catchment devices.
z Caution: do not touch running cutters.
z Always keep hands and feet away from rotating parts. Do not
stand in front of the grass ejector opening.
z Never lift or carry a lawnmower while the motor is running.
z Never open the guard flap while the motor is still running.
z Before removing the grass catchment device, turn off the mo-
tor and wait until the cutting gear has stopped running. After
emptying the grass catchment device, reattach carefully.
z Never drive across gravel while the motor is running – impac-
ting stones!
z Avoid mowing wet grass where possible.
z Switch off the lawnmower, pull the mains plug and wait for the
lawnmower to stop running if, for example:
leaving the lawnmower
unblocking a blade
intending to check, clean or work on the lawnmower
you have encountered a foreign object, in which case you
should check the lawnmower for damage and carry out any
necessary repairs.
the lawnmower is vibrating heavily (switch off immediately
and ascertain the cause).
you wish to change the settings or carry out cleaning work.
you wish to check whether the connection cables have be-
come tangled or damaged.
If the connection cable is damaged during use, it must be
immediately disconnected from the mains power supply.
Do not touch the cable before it has been disconnected
from the mains power supply.
Maintenance
1 Attention! Rotary cutter blade
Before all maintenance and cleaning work:
z Pull out the power plug.
z Do not touch running blades.
z Never spray down the lawnmower using water, especially not
at high pressure.
z Regularly check and tighten all visible screws and nuts, espe-
cially those relating to the cutting bar, to ensure a firm fit.
z Always have blades changed or re-sharpened by a specialist
workshop, since a balance test must be carried out as speci-
fied in the safety regulations following any removal of parts.
z Only use original WOLF-Garten spare parts. Otherwise we
can’t guarantee that your mower conforms to the safety regu-
lations.
z Never park your lawnmower in damp rooms.
z For safety reasons, replace worn or damaged parts.
Disposal
Assembly
Fasten handle bars
1 Caution!
The cable can be damaged while folding up or pulling out
the handle bar.
z Inlay the cable in the bend protection .
z When adjusting the handle height take care that the ca-
ble is not crimped
1. Fold the bottom part of the handle up and screw it tight with
the two hand wheels (1)
2. Set the handle to the desired height .
3. Fold the upper part of the handle out and screw it tight with the
wing nuts (2).
Mount the collecting bag
z See illustrations.
Do not dispose of electrical equipment in domestic
waste. Recycle equipment, accessories and pa-
ckaging in an environment-friendly manner.
A
B
C
A
B
C
B
C
D
E
F
G
H
J
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for WOLF-Garten Power Edition 34 E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of WOLF-Garten Power Edition 34 E in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 2,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info