517916
14
Zoom out
Zoom in
Previous page
1/124
Next page
14
G
z Always wear appropriate working clothes and
sound footwear when using the trimmer.
z Before carrying the trimmer to the next lawn
area to be cut, switch it off.
z Be careful when you go backwards. You may
stumble!
z Keep the cable away from the cutting tool.
z Should the powercord be damaged during
use, immediately disconnect it from the mains.
Do not touch the cable until it has been discon-
nected from the mains.
z Never leave the trimmer without supervision.
Store it in a safe place.
z The switches installed shall not be removed or
bridged over, e. g. by binding the switch to the
handle.
z Do not allow the cord spool to strike the ground
or edges of working area. If the cord spool re-
ceives a hard knock, this will cause a strong vi-
bration on the handle. If this occurs, the
trimmer should be checked by a qualified ser-
vice centre.
After operating
z After using the unit, disconnected the power
cord from the wall outlet and inspect the unit
for damage.
z When switching off the trimmer: Attention: the
cutting tool does not stop immediately!
z Always wait for the cutting tool is stop.
z Before examining or cleaning the tool or be-
fore removing the safety device or the cord
spool, switch off and disconnect the trimmer
from the mains. Only use original WOLF cord
spools and note the installation instructions!
z The cutting knife should not be cleaned under
running water or under high-pressure.
z Faults shall only be repaired by appointed ser-
vice centres or by the manufacturer.
z Make sure all air holes are free of dirt.
z Do not store the unit within reach of children.
Disposal
Operation
Operating times
z Please check noise abatement regulations
prevailing in your country.
Settings
The lawn trimmer is equipped with a four-position
adjustable working angle. This enables you to
easily trim hard-to-reach areas in your garden.To
set the ideal working position, please follow the in-
structions below.
3 The cutting head should be inclined
slightly forward while trimming.
Working angle and wheels
Free trimming - Working angle 1
Free trimming is especially suitable for trimming
large areas with high weeds or grass. During free
trimming, you should swing the trimmer in a semi-
circular motion in front of your body.
1. Set working angle .
2. Remove wheels .
Even trimming - Working angle 2
Recommendation: In order to achieve an even and
clean cut, you should use the wheels (see Acces-
sories).
1. Set working angle .
2. Fit wheels .
3. Position wheels .
Do not dispose of electrical equip-
ment in domestic waste. Recycle
equip-ment, accessories and packa-
ging in an environment-friendly man-
ner.
A
E
G
B
E
H
J
0054678.book Seite 14 Mittwoch, 9. Dezember 2009 1:51 13
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for WOLF-Garten GT 850 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of WOLF-Garten GT 850 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 5,08 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info