638609

WOLF-Garten Campus 460 BA Manual

13
Zoom out
Zoom in
Previous page
1/32
Next page
14
Operation
Operating times
Please check noise abatement regulations prevailing in your
country.
Oil Fill
H
Check oil level with mower standing on level ground.
Fill crankcase with quality oil SAE 30 up to the mark „Full“ on
dipstick. (Do not overfill.) Capacity approx. 0,6 litre. Screw in
dipstick according to illus.
Filling with Petrol
J
Do not smoke - no naked flames!
off engine.
Avoid spilling petrol when engine is warm.
Use „low-octane petrol“ (do not use Super Plus).
Avoid petrol spillage.
Do not inhale vapour.
Hanging the grass bag
K
Only when mower is stationary and rotating blade
has come to complete standstill.
1. Lift the protective fl ap.
2. Hang the grass bag in the chassis with the hooks in the
recesses (see arrow).
3. Replace the protective fl ap.
Use of height adjustment
L
M
Only when mower is stationary and rotating blade
has come to complete standstill.
• Place hand into handle bar and depress button (1). Lift or
lower chassis until it engages into required position (2).
• The wheels must all be at the same cutting height
setting!
• If possible, mow when grass is dry in order to protect turf.
Do not set cutting position too low when mowing very tall
or wet grass.
Start
G
N
O
• On a fl at surface, if possible not in high grass.
1. Firmly press the primer on the motor (three times)
N
(1).
2. Raise and hold the safety bracket
G
(1).
3. Pull starter grip
O
and return it slowly by hand.
4. Push the choke back as soon as the engine has warmed
Wheel drive (Campus 460 BA)
1. Wheel drive on: Raise drive bracket
G
(2).
2. Wheel drive off: Relapse drive bracket
G
(2)
Stop Motor
Release safety bracket
G
(1).
Tips for mowing
P
• To prevent strips of grass from being left unmowed, the
cutting paths must always overlap a few centimeters.
• Always turn the mower on a surface that has already been
mowed.
Emptying the grass bag
Only when mower is stationary and rotating blade
has come to complete standstill.
The grassbox is full and should be emptied as soon as grass
clippings remain uncollected on the ground behind your mower.
Maintenance
Disconnect spark plug cap and starter key before
proceeding
Clean mower thoroughly after each mowing with cloth or
brush.
Do not spray with water. Keep mower in a dry room.
Cleaning operations and blade change
Q
1. Pull off the sparkplug connector!
2. Raise the cutting height to its highest position
3. For cleaning work and blade replacement tilt the mower back
as shown in the illustration.
Change of Cutter blades
R
Disconnect spark plug cap and starter key before
proceeding
Blade should always be sharpened by an approved Service
Centre. Change blade according to drawing.
Information for Service Centre, blade retaining screw to be
tightened to: screw = 51-68 Nm.
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for WOLF-Garten Campus 460 BA at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of WOLF-Garten Campus 460 BA in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 1,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info