Manual WOLF-Garten 40 EA-1 (page 11 of 42) (English, German, Dutch, French, Italian, Turkish)

78541

Zoom out

Zoom in

1/42

z Use only extension cables with a minimum cross-section of

3x1.5mm

and a length of max. 25 m:

– When using rubber-sheathed cables, they must be of

type HO 7 RN-F or heavier.

– When using PVC-sheathed cables, they must be of type

HO5 VV-F or heavier (cables of this type are not suitable for

continuous outdoor use, e.g. underground installation for

the connection of an outdoor socket or pond pump, or out-

door storage).

z Please use safety cables. Cables used as connecting lines

must not be lighter than HO7 RN-F rubber-sheathed cables

with a minimum cross-section of 3 x 1.5 mm

. Do not exceed

a maximum length of 25 m.

z Plugs and couplings must be protected from splashes.

z Use a residual current protection device (RCD) with a residual

current not exceeding 30 mA.

z Fit the connection cable to the mains lead cleat. Do not allow

to rub against edges or against sharp or pointed objects. Do

not squeeze cables through tight door or window openings.

Switch devices must not be removed or circumvented (e.g.

connecting the switch lever to the handle bars)

When mowing

z Do not tilt the lawnmower when switching on the motor, unless

the lawnmower has to be tilted when starting. If that is the

case, do not tip the lawnmower more than absolutely neces-

sary, and only lift the part furthest removed from the user. Al-

ways ensure that both hands are in the operating position

before replacing the lawnmower on the ground.

z Caution, danger! Cutting gear will continue running!

z Maintain the safety distance prescribed by the handle bars.

z Only switch on the motor if your feet are at a safe distance

from the cutting gear.

z Take care to ensure a safe and stable position, especially on

slopes. Never run; always walk calmly forward.

z Always mow slopes at right angles to the incline; never mow

up and down.

z When mowing slopes, be especially careful when changing di-

rection.

z Never mow steep slopes.

z Be especially careful when mowing backwards and pulling the

lawnmower towards you.

z Switch the mower off when tilting it, running on empty or trans-

porting the lawnmower, e.g. to/from a lawn or along paths.

z Never use the lawnmower if safety devices are faulty or mis-

sing, such as deflector and/or grass catchment devices.

z Caution: do not touch running cutters.

z Always keep hands and feet away from rotating parts. Do not

stand in front of the grass ejector opening.

z Never lift or carry a lawnmower while the motor is running.

z Never open the guard flap while the motor is still running.

z Before removing the grass catchment device, turn off the mo-

tor and wait until the cutting gear has stopped running. After

emptying the grass catchment device, reattach carefully.

z Never drive across gravel while the motor is running – impac-

ting stones!

z Avoid mowing wet grass where possible.

z Switch off the lawnmower, pull the mains plug and wait for the

lawnmower to stop running if, for example:

– leaving the lawnmower

– unblocking a blade

– intending to check, clean or work on the lawnmower

– you have encountered a foreign object, in which case you

should check the lawnmower for damage and carry out any

necessary repairs.

– the lawnmower is vibrating heavily (switch off immediately

and ascertain the cause).

– you wish to change the settings or carry out cleaning work.

– you wish to check whether the connection cables have be-

come tangled or damaged.

– If the connection cable is damaged during use, it must be

immediately disconnected from the mains power supply.

Do not touch the cable before it has been disconnected

from the mains power supply.

Maintenance

1 Attention! Rotary cutter blade

Before all maintenance and cleaning work:

z Pull out the power plug.

z Do not touch running blades.

z Never spray down the lawnmower using water, especially not

at high pressure.

z Regularly check and tighten all visible screws and nuts, espe-

cially those relating to the cutting bar, to ensure a firm fit.

z Always have blades changed or re-sharpened by a specialist

workshop, since a balance test must be carried out as speci-

fied in the safety regulations following any removal of parts.

z Only use original WOLF-Garten spare parts. Otherwise we

can’t guarantee that your mower conforms to the safety regu-

lations.

z Never park your lawnmower in damp rooms.

z For safety reasons, replace worn or damaged parts.

Disposal

Assembly

Fasten handle bars

1 Caution!

The cable can be damaged while folding up or pulling out

the handle bar.

z Inlay the cable in the bend protection .

z When adjusting the handle height take care that the ca-

ble is not crimped

1. Fold the bottom part of the handle up and screw it tight with

the two hand wheels .

2. Set the handle to the desired height .

3. Fold the upper part of the handle out and screw it tight with the

wing nuts .

Do not dispose of electrical equipment in domestic

waste. Recycle equipment, accessories and pa-

ckaging in an environment-friendly manner.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of WOLF-Garten 40 EA-1 in the language / languages: English, German, Dutch, French, Italian, Turkish as an attachment in your email.

The manual is 1,68 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

WOLF-Garten 40 EA-1 Manual

Product: