638524
26
Zoom out
Zoom in
Previous page
1/34
Next page
26
According to law in some countries lawn mowing not allowed on Saturdays and Sundays and at certain other times (eg. at midday or after
7 p.m.). Please check noise abatement regulations prevailing in your country.
Attach lower handle section with the provided screws (fig. M1)
Attach upper handle section (fig. M2)
Fold handle upwards. Tighten round or winged nut firmly.
Fasten the cable with the enclosed clamps (fig. M3)
Assembly of cable relief holder (fig. M4/M5)
Connecting to the mains (230 Volts, A.C., 50 Hz)
The mower operates from any normal household mains supply, provided with a 13 Amps. fuse.
Note: Use a residual current device (RCD) rated for a residual current not greater than 30 mA.
Attaching of grassbox (fig. B1)
Lift deflector lid, locate grassbox hook into opening of chassis (see arrow) and replace lid.
Use of heigth adjustment (fig. B2)
Only when mower is stationary and rotating blade has come to complete standstill.
Place hand into handle bar and depress button. Lift or lower chassis until it engages into required position (see indicator).
Selection of Cutting height
If possible, mow when grass is dry in order to protect turf. Do not se cutting position too low when mowing very hight or wet grass. We
recommend an average cutting height of 4,5 cm.
Starting (fig. B3)
Switch on motor with mowerplaced on level and firm ground, not in high grass - alternatively tilt slightly.
Switch-on motor (fig. B4)
1. Depress button and hold.
2. Lift up bar and release button.
Switch-off motor (fig. B4)
Release bar.
Mowing (fig. B5)
Always let cable trail on the cut side of the lawn. Cable guidance: Place the cable rmly off the lawn or on the already cur side
of the lawn when starting to mow.
Turning
The cable relief holder enables you to move the cable from one side of the handle frame to theother. Thus you ensure that the cable always
trails on the ride of the lawn already cut-and not in front of the machine.
Emptying of grassbox (fig. B6)
Only when mower is stionary and rotating blade has come to complete standstill.
Box filling indicator: The flap drops down when grassbox is full. To ensure properfunctioning of the indicator it is important that the grilles
below are kept clean using a hand brush.
6. Maintenance:
- Switch off motor and remove mains plug before carrying out any repairs or maintenance to your mower;
- Do not clean yor mower with a hose pipe - and particularly not with a high-pressure spray;
- Inspect regularly all visible nuts and bolts - particularly ot the cutter blade - for their tightness;
- ATTENTION! Sharpening and changing of cutter blades should be done by a qualied service centre because it is necessary that the correct
balance after xing is guaranteed;
- Damaged and worn parts must always be replaced with original WOLF replacement parts as otherwise your guarantee will be invalidated;
- Your service centre should check your mower regularly and particularly after any hard obstacle hat hit the chassis and/or the cutter blades;
- Store your mower only in a dry room.
- If cutter blade hits a hard foreign object whilst mowing switch of motor immediately, remove safety key and check cutter blade carefully for damage.
Please observe these hints, as they help you to prevent damage or even accidents!
- Conduct maintenance and cleaning work only when the motor is switched off and the key has been removed.
Safety Instructions
Operating Times
Assembly
Operation
26


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for WOLF-Garten 40 E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of WOLF-Garten 40 E in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 0,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info