Manual WOLF-Garten 2.48 BA (page 15 of 34) (English, German, Dutch, Danish, French, Italian, Polish, Swedish, Norwegian, Finnish)

78341

Zoom out

Zoom in

1/34

Maintenance

Disconnect spark plug cap and starter key before

proceeding

Clean mower thoroughly after each mowing with cloth or

brush.

Do not spray with water. Keep mower in a dry room.

Cleaning operations and blade change

1. Pull off the sparkplug connector!

2. Raise the cutting height to its highest position

For cleaning and changing the blade, tip the mower to the

side as illustrated.

Sharpening and changing blade

Disconnect spark plug cap and starter key before

proceeding

Blade should always be sharpened by an approved Service

Centre. Change blade according to drawing.

Information for Service Centre, blade retaining screw to be

tightened to: screw = 38-42 Nm.

Adjusting the Bowden cable coupling

1. Raise the drive bracket (J, 3) app. 2 cm and hold.

2. Loosen the locking nut (T, 1).

3. Turn the setscrew (T, 2) left until the drive wheels are

blocked when you pull the mower backwards.

4. Tighten locking nut (T, 1).

Change oil only

While engine is warm and fuel tank empty.

Change oil after the first 5 working hours. Thereafter change

engine oil every 25 working hours and at the end of the mowing

season. Change engine oil more frequently if working under

extreme and dusty conditions. To drain the engine oil, remove

oil filler cap, tilt machine slowly to side and allow oil to drain

from the crankcase through the filler.

Oil Fill

Cleaning of Spark Plug

Check and clean regularly, reset plug gap as required (0,76 mm).

Cleaning of air filter

Refer to the engine manufacturer‘s handbook supplied.

Winter storage

• Drain fuel tank.

• Drain carburettor

- start engine, keep it running until it stops from fuel

Starvation

• Clean the whole machine thoroughly

• Change oil, 4-stroke engine.

• Prepare engine for winter storage as follows:

- Remove spark plug

- Poor one teaspoon full of engine oil into spark plug hole

Pull starter rope slowly to distribute oil evenly inside cylinder

- Replace spark plug but do not connect spark plug lead

Pull starter rope until resistance is felt (valves are now closed)

• Store mower in a cool and dry place.

We recommend: Have your mower thoroughly checked once

a year by approved Service Agent.

Operation

Start

• On a at surface, if possible not in high grass.

Cold start

1. Firmly press the primer on the motor (O, P) three times.

2. Raise and hold the safety bracket (J, 1).

3. Pull starter grip (K) and return it slowly by hand.

Wheel drive (2.48 BA, 2.48 XC, 2.53 BA)

1. Wheel drive on: Raise drive bracket (J, 3).

2. Wheel drive off: Relapse drive bracket (J, 3).

Warm start

1. Raise and hold the safety bracket (J, 1).

2. Pull starter grip (K) and return it slowly by hand.

Stop Motor

Release safety bracket (J, 1).

•

If the motor does not start in cold weather, press the primer.

• If the motor stops due to lack of fuel, rell with fuel and

press the primer rmly (three times).

Tips for mowing

• To prevent strips of grass from being left unmowed, the

cutting paths must always overlap a few centimeters.

• Always turn the mower on a surface that has already been

mowed.

Emptying the grass bag

Only when mower is stationary and rotating blade

has come to complete standstill.

The grassbox is full and should be emptied as soon as grass

clippings remain uncollected on the ground behind your mower.

Fixing of handle

Take care that the switch cable does not become caught and

crushed when folding the handlebar (fig. A, B, C).

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of WOLF-Garten 2.48 BA in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 2,65 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

WOLF-Garten 2.48 BA Manual

Product: