638021

WOLF-Garten 2.46 BS Manual

11
Zoom out
Zoom in
Previous page
1/34
Next page
11
Maintenance
Disconnect spark plug cap and starter key before proceeding (fig. W1/W2)
Clean mower thoroughly after each mowing with cloth or brush. Do not spray with water. Keep mower in a dry room.
Change oil only
While engine is warm and fuel tank empty.
Change oil after the first 5 working hours. Thereafter chane engine oil every 25 working hours and at the end of the mowing season.
Change engine oil more frequently if working under extreme and dusty conditions. To drain the engine oil, remove oil filler cap, tilt
machine slowly to side and allow oil to drain from the crankcase through the filler.
Cleaning of Spark Plug
Check and clean regularly, reset plug gap as required (0,76 mm).
Cleaning of air filter
Refer to the engine manufacturer‘s handbook supplied.
Cleaning operations and blade change (fig. W1)
Tilt the mower towards rear for cleaning operations and blade change: Detach spark plug cable. Fold upper part of handle forwards
(avoid damage to Bowden cables).
Sharpening and changing blade (fig. W3)
Blade should always be sharpened by an approved Service Centre. Change blade according to drawing.
Gloves should be worn at all times when working on the blade. Remove ignition key and spark plug lead when working on
the blade. Information for Service Centre, blade retaining screw to be tightened to: screw = 38-42 Nm.
Winter storage
• Drain fuel tank.
• Drain carburettor
- therefore start engine, keep it runninug until it automaticalli switches off.
• Clean the whole machine thoroughly
• Change oil, 4-stroke engine.
• Prepare engine for winter storage as follows:
- Remove spark plug
- Poor one spoon full of engine oil into spark plug hole
- Pull starter rope slowly to distribute oil evenly inside cylinder
- Replace spark plug but do not connect spark plug lead
- Pull starter rope until resistance is felt (valves are now closed)
• Store mower in a cool and dry place.
We recommend: Have your mower thoroughly checked once a year by approved Service Agent.
Faults and how to remedy
Remedy (X) by:
Problem Possible cause
WOLF
service
workshop
Yourself
Motor does not start or
has no power:
• Insufcient fuel in the tank
• Spark plug lead not connected
• Spark plug out of order
• Air lter dirty or oily
• Throttle lever not at „Run“
• Blade fastening screw loose
• Clutch linings worn
---
---
---
---
---
X
X
X
X
X
X
X
---
---
Uneven cutting:
• Cutting height misadjusted
• Blunt blades
• Air / duct catcher bag blocked
---
X
---
X
---
X
When in doubt, always consult a WOLF service workshop. Important: switch off the mower and disconnect the spark
plug lead before inspecting, cleaning or working on the blades.
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for WOLF-Garten 2.46 BS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of WOLF-Garten 2.46 BS in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Norwegian, Finnish as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info