813077
24
Zoom out
Zoom in
Previous page
1/83
Next page
Bedienungsanleitung Steuerung S4_2006_09_25-neu.doc Page 24 / 83
© wodtke GmbH Tübingen. All rights reserved. Subject to change without notice. Month of issue xx/2007 Art. No. 950 281
5.13 Cleaning Programme “R”
= display shows R for cleaning programme
= display shows flashing dot for feed screw operation
= display shows remaining cleaning time in seconds
The cleaning programme is carried out once an hour while the
appliance is switched on. Fan speed is increased to maximum and
pellet feed rate is reduced. This blows the lighter flue ash fraction out
of the burner pot, thus improving the combustion of the less volatile
constituents in the bed of embers. The cleaning programme reduces
the required frequency of manual cleaning.
Note:
The cleaning programme does not relieve the user from
inspecting the burner pot every day or having the appliance
serviced regularly as required.
Important Note: Fuels with a high ash content can make it
necessary for the user to clean the burner pot frequently in spite
of the cleaning programme.
5.14 Fan after-run “G OFF”
= display shows “G OFF” for fan after-run (15 minutes)
Whenever the appliance is switched off it first enters the “G OFF”
mode for 15 minutes. This can also occur as a result of an internal
error or safety shutdown. The purpose of having a fan after-run
phase after switching off the appliance is to ensure that flue gases
are safely carried away and the entire fuel in the burner pot burns
away completely. The feed screw is always off during fan after-run.
This is normally the operating state in which wodtke appliances leave
the factory. If the appliance is left plugged in for more than 15
minutes after switching off, the display will change to “stand-by”,
indicating that fan after-run is over. The fan after-run phase “G OFF”
counts as operating time.
When fan after-run is over the display either shows the “stand-by
dot” or “HE OFF”, depending on whether the stove has been
switched off manually or by an external controller (“HE OFF”).
Important information:
If the appliance is switched off during the preheating programme, the ignition element
remains active for the remaining time of the preheating programme, even if the display
shows “G OFF”. This means that the pellets in the burner pot are lit even if the
preheating programme has been aborted. The purpose of this is to burn away all the
pellets left in the burner pot, so that it will be empty at the next start and the preheating
programme can start again without difficulty. This is one reason why one should never
switch off the appliance by pulling the plug or disconnecting it from the power supply!
G
OFF
R .
120
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wodtke Frank Airplus S4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wodtke Frank Airplus S4 in the language / languages: English as an attachment in your email.

The manual is 3.18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Wodtke Frank Airplus S4

Wodtke Frank Airplus S4 User Manual - German - 76 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info