690858

Wmf LONO Milk and Choc - 13170011 Manual

8
Zoom out
Zoom in
Previous page
1/11
Next page
14 15
en
Initial operation and general information
The induction milk frother is intended for heating and frothing milk and milk substitutes. In general,
the following milk types can be used:
fresh milk, UHT milk (including from cows, sheep and goats) and lactose-free milk as well as milk
substitutes (such as soya milk) with various fat contents.
The quality and volume of the milk foam depends on the type and characteristics of the milk being
used (e.g. the fat and protein content, temperature, etc.).
Prior to initial use, clean the device as described in the section entitled „Cleaning and care.“ Any sur-
plus length of the connecting cable can be wound around the bottom of the device‘s base (6). Connect
the mains plug to an earthed wall socket, the on/off button (7) lights up in red.
The WMF LONO Milk&Choc has four programmes:
Symbol Programme Application DISC Filling volume
Hot milk foam
This thick milk foam is
perfect for use with cap-
puccino or latte macchiato
drinks.
WMF Milk System
MIN 150 ml
MAX 350 ml
Cold milk foam
This cold, creamy milk foam
is especially well suited for
frappé drinks, cocktails, iced
coffee and desserts.
MIN 150 ml
MAX 350 ml
Hot milk
This programme provides a
quick and easy way to heat
milk, e.g. for latte coffees
or cups of warm milk.
MIN 150 ml
MAX 500 ml
Hot chocolate
Use this programme to
make hot chocolate drinks
using crumbled chocolate.
WMF Choc System
milk
MIN 150 ml
MAX 350 ml
chocolate
MAX 34 g
Preparing milk foam and hot milk:
Note: Use the WMF Milk System for this programme. (Fig. A)
▪ Hold the WMF Milk System (3) by its handle and stand it vertically within the jug. A magnet then
holds the WMF Milk System (3) to the fl oor of the jug.
▪ Fill the jug (5) with chilled milk, observing the MIN and MAX level indicators (see chart). Do not
exceed the indicated maximum, otherwise milk may slosh out during preparation.
▪ Stand the jug (5) on the device base (6).
▪ Place the lid (1) on the jug (5) and apply slight pressure to ensure that it seals. Ensure that the end
of the handle of the WMF Milk System (3) is positioned within the lid mechanism.
▪ Now press the on/off button (7) repeatedly until the LED next to the symbol
of the
desired programme lights up.
▪ Approx. 3 seconds later, the preparation begins automatically. The process may be interrupted at
any time by pressing the on/off button (7) again.
▪ Once the programme has fi nished, the device switches off automatically and the programme light
go out. The on/off button (7) lights up in red.
Note: the device‘s fans may continue to run beyond the end of the programme.
▪ The jug (5) can now be removed from the base (6). To pour out the contents, remove the lid (1) and
take out the WMF Milk System (3).
Caution: the jug and handle of the WMF Milk System may be hot!
Preparing hot chocolate:
Note: Use the WMF Choc System for this programme. (Fig B)
▪ Hold the WMF Milk System (3) by its handle and stand it vertically within the jug. A magnet then
holds the WMF Milk System (3) to the fl oor of the jug.
▪ Fill the jug (5) with chilled milk, observing the MIN and MAX level indicators (see chart). Do not
exceed the indicated maximum, otherwise milk may slosh out during preparation.
▪ Stand the jug (5) on the device base (6).
▪ Add crumbled chocolate to the milk. For optimal results, we recommend breaking the chocolate
into small chunks. Alternatively, you can use ground or powdered chocolate.
▪ Place the lid (1) on the jug (5) and apply slight pressure to ensure that it seals. Ensure that the end
of the handle of the WMF Choc System (4) is positioned within the lid mechanism.
▪ Press the on/off button (7) repeatedly until the LED next to the „Hot Chocolate“ symbol
lights
up.
▪ Approx. 3 seconds later, the preparation begins automatically. The process may be interrupted at
any time by pressing the on/off button (7) again.
▪ Once the programme has fi nished, the device switches off automatically and the programme light
go out. The on/off button (7) lights up in red.
Note: the device‘s fans may continue to run beyond the end of the programme.
▪ The jug (5) can now be removed from the base (6). To pour out the contents, remove the lid (1) and
take out the WMF Choc System (4).
Caution: the jug and handle of the WMF Choc System (4) may be hot!
Warning: Always place the lid (1) on the device before switching it on. Never remove the lid (1) while
the device is running.
Note: Allow the device to cool down before reuse.
Clean the device and the WMF Milk&Choc System after each use.
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wmf LONO Milk and Choc - 13170011 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wmf LONO Milk and Choc - 13170011 in the language / languages: English, German as an attachment in your email.

The manual is 0,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info