521661
11
Zoom out
Zoom in
Previous page
1/84
Next page
11
EN
EN
Technical data
Rated voltage: 220-240 V~ 50/60 Hz
Power consumption: 960 W (version with glass pot)
Power consumption: 900 W (version with vacuum jug)
Protection class: I
Additional safety instructions
Only connect the device to properly installed earthed sockets. The wire and plug
must be dry.
Do not pull the connecting cable over sharp edges or clamp it. Do not let it hang
down and protect it from heat and oil.
Only use extension cords that are in perfect condition.
Never disconnect the mains plug from the socket by the cord or with wet hands.
Do not carry the device by the cord.
Do not place the coffee machine on hot surfaces, such as hot plates or similar, or
near open flames. The housing could melt.
Do not place the device on water-sensitive surfaces. Water spray may damage
them.
Do not switch on the device without water. Fill the fresh water tank with cold
water only to the maximum possible number of cups at the most.
Do not put any water in the device if it is switched on or still hot. Prior to filling,
switch the coffee machine off and allow to cool for five minutes.
Caution, the device is hot. Risk of scalding from escaping steam. Never swing the
filter out or open the cap during operation.
If the device will not be used for some time, disconnect the mains plug.
Stop using the appliance and/or connect it from the mains plug immediately if:
The appliance or mains cable is damaged
There is any suspicion of a fault after dropping the appliance or similar.
In such cases, send the appliance to be repaired.
Only operate the device under supervision.
Descale the device regularly.
The vacuum jug is not suitable for the microwave.
The glass pot is not suitable for the microwave.
No liability is assumed for damages in cases of misuse, improper operation, non-
observance of the descaling instructions or unprofessional repairs. Claims under
warranty are likewise excluded in such cases.
Start-up
Prior to first use and after the device was not used for a long period of time, run a
cycle through with fresh water and no ground coffee. To do so, fill the tank to the
10-cup mark (version with glass pot) or to the 8-cup mark (version with vacuum
jug), as otherwise the pot can overflow.
Setting the current time
After connecting the mains plug to a socket, the display shows the time and Set.
Set the current time by pressing the h and min buttons. To advance the time quickly,
you can hold down the h or min buttons. Confirm by pressing the Set button.
As long as you do not confirm the time by pressing Set, the set time will blink.
Note: You can also brew coffee immediately after connecting the mains plug to a
socket by pressing the start / stop button briefly.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wmf LINEO shine koffiezetter at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wmf LINEO shine koffiezetter in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 2,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info