638065
65
Zoom out
Zoom in
Previous page
1/140
Next page


 
Flat tyres are the most common cause of puncture during cycling. However,
as long as you have the necessary tools for changing tyres and inner tubes
and a spare tube or a repair kit, this need not mean the end of your cycle
ride. For bicycles with quick-releases all you need in addition are two tyre
levers and a pump .
Be sure to read chapters “Wheel Mounting” and“How to Use
Quick-Releases and Thru Axles” before wheel removal. If you
are in doubt or if you have any questions, please contact your
bicycle dealer!
 

Open the release lever of the brake (Shimano, SRAM) or shift the bolt
in the gear/brake lever at the handlebar (Campagnolo). If your bicycle has
derailleur gears, shift to the smallest sprocket. This shifts the rear derailleur
right to the outside where it does not interfere with the removal of the wheel.


If your bicycle has  (cantilever or V-brakes) you first have to un-
hook the brake cable from the brake arm. To do this, grip the brake with
one hand and press the brake pads and arms together. In this position it
should be easy to disengage the usually barrel shaped nipple or, in the case
of V-brakes, the outer cable.
If your bicycle has  from Magura, unlock its quick-
release on one side of the brake and take it off the mounting bolt.
If your bicycle has  and , loosen
the torque arm supporting the drive and braking force on the frame. Further-
more, you need to disconnect the shifting cables and the clickbox respec-
tively before removing the wheel.
If you have (hydraulic and mechanical), you should first check
the exact position and condition of the brake pads and/or wear indicators
(ear or nose-shaped metal protrusions) . In this way you will be able to tell
after the removal whether the brake pads are still in their correct position.
Read the brake manufacturer’s instructions!
Do not pull the (disc) brake lever with a removed wheel and
make sure to mount the safety locks when removing the wheel.
a
b
c
d
Rotors can become hot, so let them cool down before remov-
ing a wheel.
Please read the operating instructions of the brake and the gear
manufacturer.
If you have derailleur gears, you should shift the chain to the smallest
sprocket before removing the rear wheel. This shifts the rear derailleur right
to the outside where it does not interfere with the removal of the wheel.
Open the quick-release, as described in chapter 

If you cannot remove the wheel after releasing the lever, this is due to the
drop-out safety tabs. They come as metal catches which engage with re-
cesses in the drop outs. Just release the quick-release adjusting nut a little
and slip the wheel past the tabs.
You will find it easier to remove the rear wheel, when you pull the rear derail-
leur slightly backwards . Lift the bicycle off the ground and give the wheel
a gentle tap with your hand so that it drops out.
If you have a bicycle with thru axles, please read chapter   
.
In case you are in doubt about how to handle thru axles, please contact
your bicycle dealer.
In the case of combined derailleur and internal gear hubs the clickbox must
also be removed first before you can dismount the rear wheel, as is the case
with typical derailleur gear rear wheels.
 
Remove the cap and the fastening nut off the valve and deflate the tyre
completely . Press the tyre from the sides towards the centre of the rim.
You will find it easier to remove the tyre, if you do this around its entire cir-
cumference.
Apply a plastic tyre lever to one bead of the tyre about 5 cm beside the valve
and lever the tyre out of the rim in this area . Hold the tyre lever tight in
its position. Slip the second tyre lever between rim and tyre at a distance of
about ten centimetres on the other side of the valve and lever the next por-
tion of the bead over the edge of the rim.
After levering a part of the tyre bead over the edge of the rim you should
normally be able to slip off the whole tyre on one side by moving the tyre lever
around the whole circumference. Now you can remove the inner tube . See
to it that the valve does not get caught, as this can damage the inner tube.
If necessary you can remove the whole tyre by pulling the other tyre bead
off the rim. Repair the puncture according to the instructions of the repair kit
manufacturer or replace the inner tube by a new one.
a
b
c
d
65


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Winora Algemene at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Winora Algemene in the language / languages: English as an attachment in your email.

The manual is 4,57 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Winora Algemene

Winora Algemene User Manual - German - 144 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info