690071
8
Zoom out
Zoom in
Previous page
1/30
Next page
REMOTE CONTROL
BATTERY REPLACEMENT
1. Squeeze tabs of battery cover and at the
same time pull cover out of remote.
2. Insert battery as shown and
close battery cover.
3. Always use 3V lithium
battery CR2025.
CRADLE: The remote control
has a separate wall-mountable
storage cradle that can be
conveniently attached to any
wall using a screw.
PROPER OPERATING CONDITIONS
Operate the remote control facing the
air cleaner.
Operate within 20 feet of the air cleaner.
IMPROPER OPERATING CONDITIONS
Any location where there is inverter
lighting equipment or electronic
spontaneous lighting equipment.
When objects or furniture are located
between the remote and the air cleaner.
When air cleaner unit is located in direct
sunlight, as sunlight may interfere with the
infrared sensor.
In areas where fluorescent lighting is
flickering due to worn-out bulbs.
Keep remote control away from direct
sunlight or heaters.
A. POWER: Use the power button to turn
the power on and off. A short “beep” will
sound when the unit turns on o off.
B. AUTO Mode: Use the AUTO button to
eput air cleaner in AUTO mode.
C. FAN SPEED: By pressing up or down,
the unit will change fan speeds and enter
into manual mode.
D. TURBO: Use this button to switch
from automatic operation and begin the
maximum amount of room air cleaning and
air movement and will remain in Turbo speed
until changed into Auto or Manual mode.
BATTERY USE
Always use 3V lithium battery CR2025
Incorrect battery usage may cause
battery fluid leakage and/or damage.
When not using remote control for an
extended period, remove the battery.
Avoid dropping or damaging the
remote control.
TROUBLESHOOTING
Before You call
Solutions to Common Problems
Before you call for service, review the list below. This list covers problems that are not the result
of defective materials or workmanship.
The remote control
dose not work.
Make sure the remote control battery is inserted correctly.
dose not work.
Replace a worn-out battery.
Make sure that the remote control has a clear line of sight to
the air cleaner.
The unit has stopped
removing odors
effectively, or seems to
be emitting an odor.
Make sure the AIR QUALITY sensor is not blocked or clogged.
Move the unit closer to the offending odors.
Replace the filters as they may have reached their capacity to
absorb pollutants. You may need to replace filters more frequently.
OCCURRENCE POSSIBLE CAUSE / SOLUTION
The AIR QUALITY
LEVEL indicator is
orange or red, but the
air seems clean.
Clear the AIR QUALITY sensor with a vacuum cleaner as it may be
blocked or clogged.
Unit interferes with radio
or television reception.
Because this unit radiates radio frequency energy, try one or more
of the following suggestions:
Reorient or relocate the receiving antenna.
Increase the distance between the equipment and the air cleaner.
Connect the air cleaner to an outlet on a circuit different from that
to which the equipment is connected.
Consult an experienced television/radio technician.
The CHECK FILTER
indicator remains lit
after replacing the
Filter Cassette.
Press the RESET FILTER button by gently inserting a paper-clip into
the RESET FILTER button hole. Hold for 3-5 seconds until a “beep”
sounds to indicate the unit has been reset.
The unit does not
remove smoke and
odors in the air.
Make sure the sensor is not blocked or clogged.
- The filters may need replacement
The unit seems to
produce odors.
Move the unit closer to the offending odors.
- Replace the filter
13 14
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Winix U450EU at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Winix U450EU in the language / languages: English, German, Dutch as an attachment in your email.

The manual is 11,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info