603168
4
Zoom out
Zoom in
Previous page
1/16
Next page
NOTE: Anything in the striped area will interfere with the operation of the TRAV’LER antenna
and may cause damage to the object or the TRAV’LER antenna.
TRAV’LER Mount Installation
Verify that the “FRONT” of the transition plate is facing the front of the vehicle then place the TRAV’LER
antenna mount on the roof where you plan to install it and mark the screw holes so you can see them.
Move the TRAV’LER mount out of the installation area. It is recommended that you don’t pre-drill the-
holes.
Use a solid bead of sealant to connect these marks in the shape of the base.
Replace the TRAV’LER antenna and screw it to the roof. Check with your vehicle manufacturer for any
special screw requirements before using the supplied screws.
3. The unit must be within 3° of level for best operation.
4. Make sure that the location offers enough support to attach the TRAV’LER antenna securely.
5. Find a well ventilated location with a 110 V outlet for the TRAV’LER Interface inside the vehicle.
Make sure to clean the installation area before you begin.
You will want to decide where the wires will enter the vehicle. One coax cable per receiver and a control
cable will need to be run into the vehicle.
Warning: Do not run the wires through the striped area shown. Consult your receiver
manual for specics in the diagram.
FIGURE 3
4
!
13 inches
20 inches
INSTALLATION
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Winegard SK-3003 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Winegard SK-3003 in the language / languages: English as an attachment in your email.

The manual is 2,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info