745740

Wiking Volcanic 1 Manual

21
Zoom out
Zoom in
Previous page
1/52
Next page
21
Installation Instructions
Before You Start
Figure 1 is a cross-sectional view of your wood-burning stove. Here you
can gain an overview of the parts of which your stove consists.
1. Steel smoke deector.
2. Vermiculite smoke deector.
3. Vermiculite rear plate.
4. Vermiculite base plates.
5. Grate.
6. Vermiculite front piece.
7. Heat shield.
8. Air-regulation damper.
Please note: The combustion chamber is covered with plates made of
vermiculite, which is a heat-insulating material. These plates ensure
that the optimal combustion temperature is quickly reached, and they
must therefore remain inside in the wood-burning stove.
The steel smoke deector and the vermiculite smoke deector ensure that the passage of
smoke through the stove is as long as possible, so that the ue gasses have more time to emit
their warmth within the stove and the surrounding area. In this way you get more warmth from
the wood you add to the stove, as the warm smoke is not simply sent out through the chimney.
Arrangement of Individual Components
It is important to ensure that all individual components are in place and no damage was done
to them during transport. In Figure 1 you can see the parts that you must inspect:
1.
The steel bafe plate is hung from two hooks and equipped with two pins that serve as
protection during transportation. Remember to remove the two pins before you start using
the stove. Lift the skamol bafe plate off the combustion chamber and pull the two pins free
from the hooks.
2. The vermiculite smoke deector should rest on the side plates and be pushed all the way
back in the combustion chamber.
3. The rear plate must be pushed all the way back in the combustion chamber.
4. The base plates must lie at on bottom around the grate.
Only when you are condent that the individual components are in place, you may begin with
the installation of the wood-burning stove.
Changing the Smoke Outlet from Top Outlet to Rear Outlet
Proceed as follows to change the smoke outlet from top outlet to rear outlet:
1. Lift the top plate off the stove.
2. Remove the smoke ring on the top of the stove by unscrewing the three screws and lifting it off.
3. There is a cut-out for the ue duct in the back plate. Break off the plate within this cut-out to
make a hole that the ue duct can t into.
4. Remove the cover plate on the back of the stove by unscrewing the three screws (Torx Bit
no. 30) and lifting it off.
5. Install the cover plate on top of the stove with the three screws.
6. Place the smoke ring in the smoke outlet hole in the back of the stove and secure it with the
three screws.
7. Replace the top plate on the stove.
Fig. 1
1
2
3
4
5
6
8
7
… 21 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wiking Volcanic 1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wiking Volcanic 1 in the language / languages: English, German, Italian as an attachment in your email.

The manual is 1,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Wiking Volcanic 1

Wiking Volcanic 1 User Manual - Dutch - 36 pages

Wiking Volcanic 1 User Manual - Danish - 52 pages

Wiking Volcanic 1 User Manual - French - 36 pages

Wiking Volcanic 1 User Manual - Swedish, Norwegian - 52 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info