634269
72
Zoom out
Zoom in
Previous page
1/98
Next page
R
67
Replacing the FID
The condition and vertical position of the flame ionisation detector (FID) should be checked if
error codes 58, 59, 60, 61, or 62 occur repetitively.
To check and/or replace the FID:
1. Stop the WhisperGen and wait until the STANDBY indicator on the control panel is lit.
2. Remove the enclosure lid and wait for the engine to cool.
3. Undo the screw on top of the FID and detach the wire.
4. Undo the screw that secures the FID clip to the evaporator.
5. Lift the FID out of the evaporator, gripping the FID below the brass nut with a pair of pliers if
necessary. Twist the FID from side to side while pulling it straight up.
6. Check the FID for cracks and that the electrode tip at the bottom of the FID is protruding by at
least one millimetre. Also check that there is electrical continuity between the brass nut and
To prevent unintentional starts of the WhisperGen, heed the warning
given at the beginning of this section.
Do not touch the surfaces that are labelled as hot.
It is important not to twist the brass nut on the FID as this may
damage the FID.
WTL0039
Evaporator
Glow Plug
FID
Evaporator
FID
72


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for WhisperGen PPS16 DC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of WhisperGen PPS16 DC in the language / languages: English as an attachment in your email.

The manual is 1,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info