Whirlpool is a registered trademark of Whirlpool USA.
Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with
respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.Water and energy consumption refer
to the default setting of the programmes; selecting special options or modifying spin speed or temperature will change the consumption data.
The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also
“Troubleshooting Guide” in your Instructions for Use).
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.
** Standard Cotton programme and basis for Energy Label. For reasons of energy saving, the real water temperature may deviate from the declared cycle temperature.
Programme
Tempe-
rature
(°C)
Load
(kg)
Water
(l)
Energy
without “Rapid”
(kWh)
Approx. Programme Duration (hrs : min)
without “Rapid”with “Rapid”
Mixed403.0450.431:00–
Cotton956.055*1.852:051:55
Cotton606.0481.022:301:45
Cotton406.0480.602:301:30
Synthetics603.054*0.851:551:14
Synthetics403.0500.501:400:59
Delicates401.5500.550:45–
Wool/Handwash401.0400.550:35–
Jeans404.0410.581:301:10
White406.0480.652:45–
Light colours404.0670.501:201:00
Dark404.0410.581:401:10
Overnight606.0480.784:00–
Aqua Eco402.5190.431:00–
Speed 15´303.0300.150:15–
eCotton** 606.0480.673:30–
eCotton** 603.0340.562:30–
eCotton406.0480.613:15–
eCotton** 403.0340.472:30–
Power consumption in off-mode 0.11 W / in left-on mode 0.11 W
ADD DETERGENTS, CLOSE THE LID AND
SELECT THE PROGRAMME
“LID OPEN” INDICATION
Before starting and after end of a programme, the lamp lights to
show the the lid can be opened. As long as a wash programme is
running, the lid remains locked and must on no account be forced
open. In case you have an urgent need to open it during a running
programme, refer to “Cancel a running programme before the end”.
“Spin” button (incl. “Rinse hold”)
•Every programme has a predefined spin speed.
•Press the button to set another spin speed.
•If you select spin speed “0”, the final spinning is cancelled and
the water is drained out only. However, intermediate spin
phases remain during the rinse.
•If you select “Rinse hold”, the laundry remains in the last rinse
water without progressing to the final spin cycle, to avoid
creasing and prevent colours from changing. To activate the
“Rinse hold”, press the “Spin” button repeatedly until the
“Rinse hold” symbol on the display lights up.
-The wash programme stops to “Rinse hold” when the
“Rinse hold” symbol on the display blinks; the light of
“Start(Pause)” button also blinks.
-To terminate the “Rinse hold” by spinning the laundry, press
“Start(Pause)” - the laundry will be spun with the default
spin speed. You can also select another spin speed with the
“Spin” button before you start the spin cycle by pressing
“Start(Pause)”.
-To terminate the “Rinse hold” by draining the water without
spinning, press the “Spin” button until spin speed “0” appears
on the display; then press “Start(Pause)” to start the
draining. Do not leave the laundry to soak for too long in the
“Rinse hodl” (especially silk).
“Colours 15° ” button
•Saves energy used for water heating while maintaining a good
wash result.
•Supports colour maintenance when washing coloured laundry.
•Recommendable for lightly soiled laundry without stains.
•Make sure that your detergent is suitable for cold wash
temperatures.
•Not selectable for Cotton 70 - 95°C.
“Rapid” button
•Enables quicker washing by shortening the programme duration.
•Recommendable for small loads or only lightly soiled laundry.
PROGRAMME START
ECO MONITOR
Open the tap and press the “Start(Pause)” button. The
indication lamp next to the “Start(Pause)” button lights up.
The display shows the remaining programme time. Due to
The “Eco monitor” gives you a rough feedback about the power
consumption of the programme setting you selected. As soon as
you turn the programme selector to any programme, the “Eco
monitor” is on.
The indicator on the left is to show that the “Eco monitor”
is active. The four indicators next to it show the degree of
consumption: the less power your programme setting is
forecasted to consume, the less indicators will light up. This
depends on the programme, temperature and options selected,
and also on the size of the wash load. For that reason, the
forecasted degree of power consumption may adapt when the
washing machine detects the wash load.
PROGRAMME END
•The “Door open” indication lights up. After about a quarter
of an hour, the washing machine will switch off completely to
save energy.
1. Turn the programme selector to the “Off/O” position.
2. Close the water tap.
3. Open lid and drum and unload the machine.
4. Leave the lid open for some time to allow the interior of the
machine to dry.
CHANGE PROGRAMME AND/OR OPTIONS
AFTER PROGRAMME START
1. Press the “Start(Pause)” button to pause the programme.
The light blinks.
2. Select the new programme, temperature, any options and
another spin speed if you want.
3. Press the “Start(Pause)” button again. The new programme
continues at the same position where the previous programme
was interrupted. Do not add detergent for this programme.
CANCEL A RUNNING PROGRAMME BEFORE
THE END
The “Reset/Drain” button cancels a programme before the end.
•Press the “Reset/Drain” button for at least 3 seconds. The
water is drained out; it may last a while until you can open the lid.
SELECT ANY DESIRED OPTION
When the combination of programme and additional option(s)
is not possible, the indication lights switch off automatically.
Unsuitable combinations of options are deselected automatically.
“Prewash” button
•Only for heavily soiled loads (for example sand, granular dirt).
Increases the cycle time by approximately 15 min.
•Do not use liquid detergent for the main wash when activating
the Prewash option.
“Intensive rinse” button
•More water is added and rinse cycle is prolonged.
•This option is particularly suitable for areas with very soft
water, washing baby linen and helping people with allergies.
“Soil level” button
•Adapts the programme duration to the soil level of your
The red indicator shows that overture Porte and Service. We cannot open the door and stuck no matter how we switch off it would not recover.
Submitted on 29-8-2024 at 08:41
I get the error message "d on" on the display and the machine does not work any more. Anybody knows what this means? Or where I can find the reset button?
Submitted on 29-7-2022 at 16:13
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Whirlpool WTLS 60912 ZEN - 6TH SENSE 1200 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Whirlpool WTLS 60912 ZEN - 6TH SENSE 1200 in the language / languages: English as an attachment in your email.
The manual is 1,4 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
Others manual(s) of Whirlpool WTLS 60912 ZEN - 6TH SENSE 1200
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
