587327
3
Zoom out
Zoom in
Previous page
1/5
Next page
• Donotuseextensionleadsoradapters.
• Electricaldisconnectionmustbepossibleeitherby
unpluggingtheapplianceorbymeansofadouble-
poleswitchlocateduplinefromthesocket.
• Ensurethatthevoltageindicatedontheappliance
data plate corresponds to the domestic supply
voltage.
• Donotingestthecontents(non-toxic)oftheice
packs(ifprovided).
• Restrictthenumberoftimesyouopenthedoor.
• Thisappliancefeatures“skincondenser”
technology: the condensing unit is integrated into
thewallsofthefreezer.Forthisreasonthesideand
front walls of the product may become hot while
the product is running. This is entirely normal and
alsoreducestheriskofcondensationformingin
particularly critical environmental conditions (see
paragraph“Troubleshootingguide”).
APPLIANCE DEFROSTING
The appliance should be defrosted when the thickness of
ice on the walls reaches 5-6 mm.
Disconnect the appliance from the power supply.
Remove food from the appliance and put it in a very cool
place or a thermally insulated bag.
Leave the appliance door open.
Remove the internal defrost water drain plug (depending
on model) (Fig. 8).
Remove the external defrost water drain plug (depending
on model) and reposition it as shown in Fig. 8.
Use the separator (depending on model) inside the
product as a recipient for any remaining water, (D) as
shown in Fig. 8. If there is no separator, use a shallow
container.
Defrosting can be sped up by using a spatula to detach
the frost from the appliance walls.
Remove the frost from the bottom of the appliance.
In order to avoid permanent damage to the
applianceinterior,donotusepointedorsharp
metal instruments to remove the ice.
• Donotuseabrasiveproductsorheatuptheinterior
articially.
• Drytheinsideoftheappliancethoroughly.
Ret the plug after defrosting.
CLEANING AND MAINTENANCE
Remove the frost from the upper edges (see
Troubleshooting Guide).
Clean the inside after defrosting, using a sponge
dampened with warm water and/or mild detergent.
Clean the side vent (if provided).
Unplug the appliance before carrying out maintenance
operations.Donotuseabrasiveproducts,scourers
orstain-removers(e.g.acetone,trichloroethylene)to
clean the appliance.
Toobtainthebestresultsfromyourappliance,carry
out cleaning and maintenance at least once a year.
CHANGING THE LID LIGHT BULB (if provided)
Disconnect the appliance from the mains power supply.
Remove the diuser by following the sequence of steps
shown in the gure.
Unscrew the light bulb and replace it with an identical
bulb of the same wattage and voltage.
Ret the diuser and plug in the appliance.
TROUBLESHOOTING GUIDE
1.TheredLEDashes.
Is there a power failure?
Is a defrosting operation in progress?
Has fresh food recently been introduced?
Is the appliance lid properly closed?
Is the appliance placed near a heat source?
Are the ventilation grille and condenser clean?
2.AllLEDsashatthesametime.
Contact the After-Sales Service.
3. The appliance is too noisy.
Is the appliance perfectly horizontal?
Is the appliance in contact with other furniture or
objects that may cause vibrations?
Has the packaging been removed from under the
appliance?
Note: Gurgling noises from the refrigerating circuit after the
compressor cuts out are perfectly normal.
4.AllLEDsareoandtheproductisnotworking.
Is there a power failure?
Is the plug properly inserted in the socket?
Is the electric cable intact?
5.AllLEDsareoandtheproductisworking.
Contact the After-Sales Service.
6. The compressor runs continuously.
Have hot foods been put in the appliance?
Has the appliance lid been left open for a long time?
Is the appliance placed in a very warm room or near
heat sources?
Has the fast freeze function been activated? (the
green LEDS ash alternatively)
7. Too much ice on the upper edge.
Are the defrost water drainage plugs correctly
positioned?
Is the appliance lid properly closed?
Is the appliance lid seal damaged or deformed?
(See chapter “Installation”)
Have the 4 protection pieces been removed?
(See chapter “Installation”)
8. Formation of condensate on the external walls of
the appliance.
It is normal for condensation to form under certain
atmospheric conditions (humidity above 85%) or if the
appliance is located in a damp or poorly ventilated
room. The performance of the appliance is in no way
aected.
9. The layer of ice on the internal walls of the
appliance is not uniform.
This phenomenon is quite normal.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool WHE22333 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool WHE22333 in the language / languages: English as an attachment in your email.

The manual is 0,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool WHE22333

Whirlpool WHE22333 User Manual - German - 4 pages

Whirlpool WHE22333 User Manual - Dutch - 5 pages

Whirlpool WHE22333 User Manual - French - 5 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info