757663
4
Zoom out
Zoom in
Previous page
1/4
Next page
4
4. All LEDs are off and the product is not working.
Is there a power failure?
Is the plug properly inserted in the socket?
Is the electric cable intact?
5. All LEDs are off and the product is working.
Contact the After-Sales Service.
6. The compressor runs continuously.
Have hot foods been put in the appliance?
Has the appliance lid been left open for a long time?
Is the appliance placed in a very warm room or near heat
sources?
Has the fast freeze function been activated?
(The green LEDs flash alternatively)
7. Too much ice on the upper edge.
Are the defrost water drainage plugs correctly
positioned?
Is the appliance lid properly closed?
Is the appliance lid seal damaged or deformed?
(See chapter “Installation”)
Have the 4 protection pieces been removed?
(See chapter “Installation”)
8. Formation of condensate on the external walls of
the appliance.
It is normal for condensation to form under certain
atmospheric conditions (humidity above 85%) or if the
appliance is located in a damp or poorly ventilated room.
The performance of the appliance is in no way affected.
9. The layer of ice on the internal walls of the
appliance is not uniform.
This phenomenon is quite normal.
AFTER‑SALES SERVICE
Before contacting After‑Sales Service:
1. See if you can solve the problem yourself.
2. Switch the appliance on again to see if the problem has
been solved. If it has not, disconnect the appliance from
the power supply and wait for about an hour before
switching on again.
3. If the problem persists after this course of action,
contact After-Sales Service.
Specify:
the nature of the fault,
the model,
the service number (the number after the word
SERVICE on the rating plate on the rear of the
appliance)
your full address,
your telephone number and area code.
400011234464
ELECTRICAL CONNECTION FOR GREAT BRITAIN AND IRELAND ONLY
Warning – this appliance must be earthed.
Fuse replacement
If the mains lead of this appliance is tted with a BS 1363A 13amp fused plug, to
change a fuse in this type of plug use an A.S.T.A. approved fuse to BS 1362 type
and proceed as follows:
1. Remove the fuse cover (A) and fuse (B).
2. Fit replacement 13A fuse into fuse cover.
3. Ret both into plug.
Important:
The fuse cover must be retted when changing a fuse and if the fuse cover is lost
the plug must not be used until a correct replacement is tted.
Correct replacement are identied by the colour insert or the colour embossed in words on the base of the plug.
Replacement fuse covers are available from your local electrical store.
For the Republic of Ireland only
The information given in respect of Great Britain will frequently apply, but a third type of plug and socket is also used, the
2-pin, side earth type.
Socket outlet / plug (valid for both countries)
If the tted plug is not suitable for your socket outlet, please contact After-sales Service for further instruction.
Please do not attempt to change plug yourself. This procedure needs to be carried out by a qualied technician in
compliance with the manufactures instructions and current standard safety regulations.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool WH1410E2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool WH1410E2 in the language / languages: English as an attachment in your email.

The manual is 0,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool WH1410E2

Whirlpool WH1410E2 User Manual - German - 4 pages

Whirlpool WH1410E2 User Manual - Dutch - 4 pages

Whirlpool WH1410E2 User Manual - French - 4 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info