6
In case of power failures of up to 24 hours
Keep the doors of the appliance closed. In this way the stored food will stay cold as long as possible.
For further information see chapter “Using the appliance”, section “Black-out alarm”.
If the appliance is not going to be used
- Disconnect the appliance from the power supply.
- Remove all the food if you are going away for more than three weeks.
- If the appliance has an automatic ice-maker:
1. Shut off the water supply to the automatic ice-maker.
2. Empty the ice bucket.
- Leave the doors open enough for air to circulate inside the compartments. This will prevent the
formation of mould and bad odours.
• Before any cleaning or maintenance operation, always
disconnect the appliance from the power supply.
• Periodically clean the appliance with a cloth and a solution of
lukewarm water and neutral detergent specific for refrigerator
interiors.
• Never use detergents or abrasives. Never clean the refrigerator
parts with flammable liquids. The fumes can cause fires or
explosions.
• Clean the outside of the appliance and the door seals with a
damp cloth and dry with a soft cloth.
• Do not use steam cleaners.
• Clean the condenser using a vacuum cleaner, remove the front
kickplate (see installation handbook).
• The buttons and control panel display (located on the freezer
door on some models) must be cleaned with a dry cloth; do not
use alcohol or alcohol-derived substances.
• The refrigerant system pipes are located near the defrost pan
and can become very hot. Periodically clean them with a vacuum
cleaner.
Replacing light bulbs
Attention
• Always disconnect the refrigerator from the power supply
before replacing any light bulbs.
• Before replacing the light bulb, remove the light guard that may
be present. This will have to be put back after replacing the light
bulb.
• The refrigerator accepts light bulbs with a bayonet type mount.
These do not need unscrewing/screwing when replacing.
• The ice/water dispenser light bulb has a standard screw type
mount and therefore needs to be screwed in place.
Replace the lamp with one of the same type, available from the
After-sales Service or from authorised dealers.
MAINTENANCE AND CLEANING
IF THE APPLIANCE IS NOT GOING TO BE
USED
