702187
10
Zoom out
Zoom in
Previous page
1/19
Next page
User manual
10
5. Add detergent
Pull out the detergent dispenser and add
detergent (and additives/softener) into the relative
compartments as described in section “DETERGENT
DISPENSER”. Observe the dosing recommendations
on the detergent pack.
Correct dosing of detergent / additives is important, because:
it optimizes the cleaning result
it avoids irritating residues of surplus detergent in your
laundry
it saves money by avoiding waste of surplus detergent
it protects the washing machine by avoiding
calcication of components
it respects the environment by avoiding unnecessary
environmental burden.
6. Delaying the start of a programme
To set a programme to start at a later time, see the
section “OPTIONS/ START DELAY”
7. Start programme
Press the “Start/Pause” . The relative indicator lamp
illuminates, the door locks and the “Door locked”
indicator lights up.
To avoid overow, do not open the detergent
dispenser during a running programme anymore.
The remaining programme duration can vary. Factors
like unbalance in the wash load, or foam formation, can
have an eect on the programme duration.
8. Change the settings of a running programme, if
needed
You can still change the settings while a programme is
running. The changes will be applied, provided the respective
programme phase has not nished yet.
To change the settings of a running programme:
Press “Start/Pause” to put the running programme
on pause.
Change your settings.
Press “Start/Pause” again to continue the
programme.
If you have changed the programme, do not add detergent
for the new programme.
To prevent that a running programme is changed by accident
(for instance by children), use the “Key lock” (see section
“FUNCTIONS).
Pause a running programme and open the door, if
needed
Press “Start/Pause” to pause a running programme.
Provided water level or temperature is not too high,
the “Door locked” indicator light turns o. You can
open the door, for example to add more laundry, or to
remove laundry which was loaded by mistake.
Press “Start/Pause” to proceed with the
programme.
9. Cancelling a running programme, if needed
Press and hold the “ON/OFF button until the
washing machine stops.
If the water level and temperature are low enough, the
door unlocks and may be opened.
The door remains locked if there is water in the drum.
To unlock the door, switch the washing machine on,
select the "Spin & Drain" programme and turn the spin
option o by setting the spin speed to “0“.
The water is emptied and the door unlocks at the end
of the programme.
10. Switch o the washing machine after programme End
At the end of the cycle, the message "END" is shown on
the display.
The door can only be opened when the symbol “Door
locked” light turns o.
Check that the “Door locked” indicator is o, then
open the door and take out the laundry.
Press “ON/OFF to switch the washing machine o.
To save energy, if the washing machine is not switched
o manually with the button, it turns o automatically
approximately 30 minutes after the end of the programme.
Leave the door ajar to let the interior of the washing
machine to dry.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool FWGBE91484 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool FWGBE91484 in the language / languages: English as an attachment in your email.

The manual is 5,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool FWGBE91484

Whirlpool FWGBE91484 User Manual - German - 20 pages

Whirlpool FWGBE91484 User Manual - Dutch - 19 pages

Whirlpool FWGBE91484 User Manual - French - 20 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info