709230
15
Zoom out
Zoom in
Previous page
1/19
Next page
EN
User manual
15
TROUBLESHOOTING
Your washing machine is equipped with various automatic
safety and feedback functions. They enable failures
and needed maintenance to be detected and indicated
accordingly.
These failures are frequently so minor that they can be
removed within a few minutes.
Anomalies: Possible causes / Solution:
The washing machine does not
turn on.
The plug is not inserted into the electrical outlet, or not enough to make contact.
There has been a power failure.
The door is not fully closed.
The wash cycle does not start.
The “ON/OFF button has not been pressed.
The “Start/Pause”
button has not been pressed.
The water tap is not open.
A “Start delay” has been set.
The washing machine does not ll
with water (the message “h2o” is
shown on the display). “Beep”
sound every 5 seconds.
The water intake hose is not connected to the tap.
The hose is bent.
The water tap is not open.
The mains water supply has been shut o.
There is not enough pressure.
The washing machine loads and
drains water continuously.
The “Start/Pause”
button has not been pressed.
The drain hose has not been installed at 65 to 100 cm from the ground.
The end of the drain hose is immersed in water.
The drain connector on the wall does not have an air vent.
If the problem persists after having performed these checks, close the water tap,
shut o the washing machine, and call the After-sales service. If the dwelling is
located on one of the uppermost oors of a building, a siphon eect can
sometimes occur, thus causing the washing machine to load and drain water
continuously. Special anti-siphon valves are available on the market to prevent
these types of problems.
The washing machine does not
drain or does not spin.
The programme does not include the draining function: with certain programmes
it must be activated manually.
The drain hose is bent.
The drain line is obstructed.
The washing machine vibrates
excessively during the spin cycle.
At the time of installation, the drum was not properly unblocked.
The washing machine is not level.
The washing machine is squeezed between furniture and the wall.
The washing machine leaks water.
The water intake hose has not been tightened properly.
The detergent dispenser is clogged.
The drain hose has not been properly fastened.
The machine is locked and the
display ashes, indicating an
error code (e.g. F-01, F-..).
Shut o the machine, disconnect the plug from the outlet, and wait about 1
minute before turning it back on.
If the problem persists, call the After-sales service.
Too much foam is formed.
The detergent is not compatible with the washing machine (it must bear the
wording “for washing machines”, “for hand washing and washing machines”, or
something similar).
The dosage was excessive.
Door is locked, with or without
failure indication, and the
programme does not run.
Door is locked in case of power breakdown. Programme will continue
automatically as soon as the mains is available again.
Washing machine is in a standstill. Programme will continue automatically after
the origin of the standstill does not persist anymore.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool FWF71483WE EU at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool FWF71483WE EU in the language / languages: English as an attachment in your email.

The manual is 6,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool FWF71483WE EU

Whirlpool FWF71483WE EU User Manual - German - 19 pages

Whirlpool FWF71483WE EU User Manual - Dutch - 19 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info