Manual Whirlpool FSCR 10433 (page 7 of 8) (English)

607070

Zoom out

Zoom in

1/8

Refer to the Programme Chart to check if options are available for the

selected programme

OPTIONS which are directly selectable by pressing the

dedicated button

Fresh Care

Helps to keep your laundry fresh if you cannot unload it

soon after programme end.

The washing machine will start to tumble the laundry

periodically a short time after programme end. This tumbling will

last up to approximately 6 hours after end of your wash programme.

You can stop it at any time by pressing any button; the door unlocks

and you can take out your laundry.

OPTIONS which are selectable by pressing the Options

button

Prewash

Helps to clean heavily soiled laundry by adding a prewash

phase to the wash programme selected.

Extends the programme by about 20 minutes.

For adding detergent to the prewash phase

• automatically: make sure that the auto dosing system is activated

(see FUNCTIONS / Auto Dosing)

• manually: add the detergent portion for the prewash phase

directly to the drum in a detergent ball, before starting the

programme.

Hot Finish

The programme ends with a warm rinse phase. This relaxes

the bres of your laundry, and the laundry feels

comfortably warm when taking it out a short time after

programme end.

Bio Stains 15°

Helps to remove all kinds of stains, except grease/oil.

The programme begins with a cold water wash phase.

Extends the programme by about 10 minutes.

Pre-treatment recommended for stubborn stains.

Not selectable for Cotton 95°C.

Colours 15°

Helps to preserve the colours of your laundry by

washing it with cold water (15°C). Saves energy for

water heating, while keeping a good wash result.

Suitable for lightly soiled coloured laundry without stains.

• Make sure that your detergent is suitable for cold wash

temperatures (15 or 20 °C).

• Not selectable for Cotton 95 °.

Heavy Soil

Helps to clean heavily soiled, stained laundry by optimising

the eciency of additives for stain removal.

Add an appropriate amount of in-wash additive for stain

removal (powder) to the manual detergent dosing compartment,

together with your detergent (powder only). May extend the

programme by up to 15 minutes.

Appropriate for use with oxygen-based stain removers and

bleaching agents.

Chlorine or perborate bleaches must not be used!

Intensive Rinse

Helps to avoid detergent residues in the laundry by

extending the rinse phase.

Particularly suitable for washing baby laundry, for people

suering from allergies and for areas with soft water.

Rapid

Enables quicker washing.

Recommendable for only lightly soiled laundry.

Not selectable for Cotton 95 °C.

FUNCTIONS

Auto Dosing

Automatically dispenses liquid detergents and

fabric softener (if needed) from the tanks of the

detergent dispenser. To enable a correct dosage, this

function needs to be set up as mentioned in section

FIRST TIME USE/Auto Dosing, and as described in

detail in the USE AND CARE GUIDE/AUTO DOSING –

FIRST USE.

Once you have completed the set-up, make sure that

the tanks are lled with detergent/fabric softener according to the

selected conguration:

• If you use fabric softener:

» Tank 1: detergent

» Tank 2: fabric softener

In this conguration, when setting up a programme, Tank 1 and

Tank 2 buttons light up to indicate that the right amount of

detergent and softener will be dispensed, once the programme is

started. If in certain cases you do not want to dispense softener,

simply disable Tank 2 by pressing the corresponding button.

• If you do not use fabric softener:

» Tank 1: main detergent

» Tank 2: secondary detergent

In this conguration, when setting up a programme, you can only

select one tank. Make sure that the correct tank is selected,

according to the detergent you want to use for the selected

programme. The detergent will be dispensed only from the tank for

which the related button lights up.

If occasionally you prefer to dose the detergent manually (for

instance because you want to use another detergent), simply

deactivate the tanks by pressing the buttons, and add the detergent

in the compartment for manual dosing. The deactivation of the

tanks will be valid only for one programme. The Auto Dosing

function will automatically be active again for the next programme

which you set up.

When the supply of detergent/fabric softener in one of the tanks

runs low, the display shows a low level warning when the washing

machine is switched on, and also at the end of the programme. In

addition, the corresponding tank button light blinks a few times.

When this message appears for the rst time, the supply in the

indicated tank is usually sucient for about two or three more

programmes.

When the supply of detergent/fabric softener in one of the tanks

has run out completely, the display shows an empty tank warning

and informs that only manual dosing is possible. The button light of

the empty tank blinks a few times. You have to either rell the

empty tank(s), or dose the detergent manually.

In case you want to permanently deactivate the Auto Dosing

function (because you always prefer to dose manually), press the

Settings button, select Auto Dosing and set the function to O. To

be able to use the function again later, it must be set to On.

IMPORTANT:

• Never ll the tanks with powder detergents; powder can only be

used for manual dosing

• Softener cannot be dosed manually; it can only be used in Tank 2

of the auto dosing system.

OPTIONS, FUNCTIONS AND INDICATORS

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool FSCR 10433 in the language / languages: English as an attachment in your email.

The manual is 7,7 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool FSCR 10433

Whirlpool FSCR 10433 Quick start guide - French - 8 pages

Whirlpool FSCR 10433 User Manual - French - 55 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Whirlpool FSCR 10433 Manual

Product: