756830
4
Zoom out
Zoom in
Previous page
1/4
Next page
You can download the Safety Instructions, User Manual, Product Fiche and Energy data by:
Visiting our website - docs.whirlpool.eu
Using QR Code
Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When
contacting our After-sales Service, please state the codes provided on your product’s identi cation plate.
THANK YOU FOR BUYING A WHIRLPOOL PRODUCT.
In order to receive a more complete assistance,
please register your product on
www.whirlpool.eu/register
EN
Quick guide
Before using the appliance carefully read the Safety Instructions.
xxxxxxxxxxxx
xxxx
Before using the appliance carefully read the Safety Instructions.
xxxxxxxxxxxx
xxxx
TROUBLESHOOTING
Before contacting the Service Centre, refer to the table below. Often the malfunctions are minor and can be solved in few minutes.
Possible cause
Solution
The tumble
dryer does not
turn on.
The plug is not inserted into the socket.
Insert the plug into the socket.
The plug is faulty. Try to plug another appliance in the same socket. Do not use
connecting electrical devices to the socket, as adapters or extensions.
A power failure occurred. Await the reactivation of the power supply.
The tumble
dryer does not
start.
The door is open.
Close the door.
A time delay for the cycle start was set. For machines equipped with this function: await the end of the delay
set or switch the machine o to reset it. Refer to the section Options.
The button Start/Pause was not pressed to start
the program.
Press the button Start/Pause.
The function Key Lock was enabled (in case of
machines equipped with this option).
Refer to the option section and, if the Key Lock is present, disable it.
Switching the machine o is not enough to disable this option.
The drying
times are very
long.
An appropriate maintenance was not carried
out.
Refer to the section Care & Maintenance and perform the operations
described.
The programme, the time and/or the drying
level set are not suitable for the type and the
amount of load inserted into the dryer.
Refer to the section programmes and options to  nd the programme
and the options most suitable for the type of load.
The garments are too wet.
Carry out a washing cycle with higher spin speed to remove as much
water as possible.
The dryer may be overloaded. Refer to the programme section to check the max. load for each
programme.
Room temperature. The drying time may be longer if the room temperature falls outside the
14–30°C range.
The programme
A power failure occurred might have occurred. In case of power failure, it is necessary to press the button Start/Pause
to restart the cycle.
nishes and
clothes are
damper than
Small load.
The automatic programme has not sensed the required  nal moisture
and the dryer will complete the programme and stop. If this happens
simply select an additional short period of drying or select extra dry
option if available.
Lights on or  ashing
Water tank The water tank is full. Empty the water tank. Refer to the section Care & Maintenance.
Door  lter
and/or bottom
Failure of the air  ow necessary for machine
operation.
Clean the door  lter and the bottom one and check whether air
intake is free. Carrying out these operations improperly may cause
damages.
Bottom  lter* The bottom  lter requires cleaning. Clean the bottom  lter. Refer to section Care & Maintenance.
DEMO
The cycle lasts
few minutes.
The dryer is in DEMO mode. The DEMO
indicator is on.
Disable the DEMO mode. The following actions must be carried out
in sequence, without breaks. Switch the machine on and then switch
it o again. Press the Start/Pause button until the buzzer is heard.
Switch the machine on again. The “DEMO indicator  ashes and then
turns o .
The presence
of wrench
symbol signals a
malfunction.
The machine sensors detected a failure.
Switch the dryer o and unplug it. Open the door immediately and
pull laundry out, to allow the heat to dissipate. Wait for about 15
minutes. Reconnect the dryer to the power supply, load the laundry
and restart the drying cycle. If the problem still occurs, contact
the After-Sales Service Centre and communicate the letters and
digits  ashing on the display.
For instance: F3 and E2.
*Note: some models are self-cleaning and not equipped with bottom  lter. Please refer to the section Care & Maintenance.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool FFTM1182NL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool FFTM1182NL in the language / languages: English as an attachment in your email.

The manual is 3,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool FFTM1182NL

Whirlpool FFTM1182NL Quick start guide - German - 4 pages

Whirlpool FFTM1182NL Quick start guide - Dutch - 4 pages

Whirlpool FFTM1182NL Quick start guide - French - 4 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info