Manual Whirlpool DLCE 71469 (page 2 of 2) (English)

650530

Zoom out

Zoom in

1/2

CONSUMPTION DATA

Power consumption in off-mode 0.16 W / in left-on mode 0.16 W

Consumption values were measured in normalized conditions, in compliance with IEC/EN 60456. In the home, they may vary depending on the individual water

supply pressure and temperature, the load and the type of wash. The consumption data indicated are based on an inlet water temperature of approx. 15°C through

the cold ﬁll valve as well as the hot ﬁll valve (if available). If your washing machine has a hot ﬁll valve, connection of this valve to hot water supply will lower the

energy consumption by reduced heating times, depending on the individual hot ﬁll inlet water temperature. Water and energy consumptions refer to the default setting

of the programmes, with temperature and load as indicated in the table; selecting any options or changing the spin speed will also change the consumption data.

he programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also

“Troubleshooting Guide” in your Instructions for Use).

* Reference programmes for Energy Label. For reasons of energy saving, the real water temperature may deviate from the declared cycle temperature.

** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.

*** Automatic adaptation of programme duration after detection of wash load.

**** After programme and spinning with maximum selectable spin speed, in default programme setting.

Programme

Tempe-

rature

(°C)

Load

(kg)

Water

(l)

Energy

(kWh)

without “Rapid”

Approx. programme duration

(hours : minutes)

Approx. remaining

moisture content (%)****

without “Rapid” with “Rapid” 1200 rpm 1400 rpm

Mixed 40 4.0 48 0.40 1:00 - 59 55

Cotton 95 7.0 74** 2.20 2:40 -

59 55

Cotton 60 7.0 51 1.19 2:20 1:35

Cotton 40 7.0 71 1.05 2:40 1:15

Synthetics 60 3.0 50** 1.00 2:05 1:12

40 35

Synthetics 40 3.0 44 0.61 1:50 0:57

Delicates 40 1.5 60 0.60 0:50 -

Delicates 30 1.5 60 0.40 0:46 -

Wool/ Handwash 40 1.0 50 0.60 0:40 -

Wool/ Handwash cold 1.0 50 0.10 0:35 -

Jeans 40 4.0 53 0.46 1:30 1:10

White 40 7.0 64 0.65 2:20 -

Light colours 40 4.0 50 0.45 1:20 -

Dark 40 4.0 40 0.53 1:40 1:15

Speed 15’ 30 3.0 20 0.08 0:15 -

AquaEco 40 3.0 19 0.43 1:00 -

Cotton * 60 7.0 50 0.60 3:50 -

53 53 Cotton * 60 3.5 35 0.56 3:10 *** -

Cotton * 40 3.5 35 0.46 3:10 *** -

- the sensor technology adapts water, energy and programme duration to the size of your wash load.

ADD DETERGENTS, CLOSE THE DOOR AND

SELECT THE PROGRAMME

Load the laundry, close the door and turn the programme selector

to the desired programme; the “Start/Pause” indicator blinks. The

temperature and spin speed shown on the display can be altered by

pressing the “Temperature” button or the “Spin” button.

If you do not use the “Dosing Aid”, add detergent now.

Your washing machine is designed to save energy. After the end of a

programme, or when a programme is selected but not yet started, the

washing machine will therefore switch off automatically after about a

quarter of an hour. To switch the washing machine on again, turn the

programme selector to “O” and afterwards to the desired programme

again.

SELECT ANY DESIRED OPTION

When the combination of programme and additional option(s) is

not possible, the indication switch off automatically. Unsuitable

combinations of options are deselected automatically.

“Colours 15°” button

• Saves energy used for water heating while maintaining a good

wash result.

• Supports colour maintenance when washing coloured laundry.

• Recommendable for lightly soiled laundry without stains.

• Make sure that your detergent is suitable for cold wash

temperatures (15 or 20°C).

• Not selectable for Cotton 70 - 95°C.

“Intensive rinse” button

• More water is added and rinse cycle is prolonged.

• This option is particularly suitable for areas with very soft water,

washing baby linen and helps people with allergies.

“Rapid” button

• Enables quicker washing by shortening the programme duration.

• Recommendable for only lightly soiled laundry.

• Not selectable for Cotton 70 - 95°C.

“Prewash” button

• Adds a prewash cycle to the wash programme selected; prolongs

the programme by about a quarter of an hour.

• Recommended for heavily soiled laundry (e.g. with sand or

granular dirt).

• Do not use liquid detergent for the main wash when activating the

“Prewash” option.

“Soil level” button

• Adapts the programme duration to the soil level of your laundry.

Also inﬂuences the detergent quantity recommendation when

using the “Dosing Aid” button.

= lightly soiled - = normally soiled - = heavily soiled.

Not all soil levels are selectable for each programme.

“Spin” button (incl. “Rinse hold”)

• Every programme has a predeﬁned spin speed.

• Press the button to set another spin speed.

• If you select spin speed “0”, the ﬁnal spinning is cancelled and

the water is drained out only. However, intermediate spin phases

remain during the rinse.

• If you select “Rinse hold”, the laundry remains in the last rinse

water without progressing to the ﬁnal spin cycle, to avoid creasing

and prevent colours from changing. To activate the “Rinse hold”,

press the “Spin” button repeatedly until the “Rinse hold” symbol on

the display lights up.

- The wash programme stops to “Rinse hold” when the “Rinse

hold” symbol on the display blinks; the light of “Start/Pause”

button also blinks.

PROGRAMME START

Open the tap and press the “Start/Pause” button . The indicator next to

the “Start/Pause” button lights up.

CHILD LOCK

Activating the child lock prevents children from starting a wash cycle or

changing the settings of a running programme. The child lock cannot

be activated or deactivated when the programme selector is in the “O”

position. To activate the child lock:

• Turn the programme selector to a programme position, or run a

programme as usual.

• Press the 2 buttons marked with the key symbol simultaneously

for at least 3 seconds. A key-like symbol will shortly appear on the

display to indicate that the child lock is active.

Any time you try to change a programme setting with active child

lock, the display will brieﬂy show the key-like symbol. The programme

setting cannot be changed anymore. The only change possible is to

switch the washer off by turning the programme selector to the “O”

position.

To deactivate the child lock:

• Press again the 2 buttons marked with the key symbol

simultaneously for at least 3 seconds.

FAILURE INDICATION

In case of any failures or irregularities, consult the “Troubleshooting

Guide” in your Instructions for Use.

“Water tap closed”: no or not sufﬁcient inlet water.

“Service” : failure or malfunction of an electrical component.

“Clean pump”: waste water is not pumped out.

Spin speed on display blinks: unbalance during spinning.

PROGRAMME END

The “Door open” indicator lights up, and the display shows “End”.

After about a quarter of an hour, the washing machine will switch

off completely to save energy.

1. Turn the programme selector to the “O” position.

2. Close the water tap.

3. Open the door and unload the machine.

4. Leave the door ajar to allow the drum to dry.

DETERGENT OVERDOSAGE INDICATION

The symbol will light up at the end of the programme if you used too

much detergent. Use less detergent next time. If the symbol lights up

and the display shows “Fod”, too much foam interrupted the wash

process; refer to the “Troubleshooting Guide” in your Instructions for

Use.

CHANGE PROGRAMME AND/OR OPTIONS

AFTER PROGRAMME START

Press the “Start/Pause” button to pause the programme. The light

blinks.

2. Select the new programme, temperature, any options and another

spin speed if you want.

3. Press the “Start/Pause” button again. The new programme

continues at the same position where the previous programme was

interrupted. Do not add detergent for this programme.

CANCEL (RESET) A RUNNING PROGRAMME

BEFORE THE END

The “Reset/Drain” button cancels a programme before the end.

• Press and hold the “Reset/Drain” button for a few seconds; an

animation appears on the display. The water is drained out; it may

last some time until you can open the door.

- To terminate the “Rinse hold“ by spinning the laundry, press

“Start/Pause” - the laundry will be spun with the default spin

speed. You can also select another spin speed with the „Spin“

button before you start the spin cycle by pressing “Start/Pause”.

- To terminate the “Rinse hold“ by draining the water without

spinning, press the “Spin“ button until spin speed “0“ appears on

the display; then press “Start/Pause” to start the draining.

- Do not leave the laundry to soak for too long in the “Rinse hold”

(especially silk).

SET CYCLE END

With this function you can postpone your programme to complete

at a later time: press the button to select in how many hours the

programme shall be ﬁnished. Thus, it allows you to have your laundry

ready at a particular time and to proﬁt from more favorable energy

rates during the night, for example. Do not use liquid detergent when

activating “Cycle end” option.

• The time until the “Cycle end” can be selected in full hour time

segments (1 to 24 h). When you press the button, the shortest

possible time will be displayed; keep on pressing the button to

loop through all the available times. To remove it again, keep on

pressing the button until you see the value “0:00”.

• When you have selected the desired time until the “Cycle end”,

press “Start/Pause” - the countdown will begin.

• During the countdown, you can still modify the programme

setting (select or deselect options, change spin speed etc.). If the

modiﬁcations prolong the programme duration so that it overruns

the originally set time until the “Cycle end”, the programme will

start immediately.

• Sometimes the programme may ﬁnish before the selected time

until the “Cycle end” has expired (e.g. for small loads). In this case,

the washing machine will tumble the laundry regularly to keep

it fresh, until the selected “Cycle end” time has expired. During

tumbling, the display will show an animation. The tumbling phase

can be stopped at any time either by pressing any button or by

rotating the programme selector; the animation will stop and the

door will unlock in about 1 minute as indicated on the display.

DETERGENT DOSING RECOMMENDATION

With the “Dosing Aid” button, you can make your washing machine

indicate you the recommended detergent quantity for your wash load,

depending on the soil level selected and the size of the load.

• Helps to save detergent and protect the environment and also

sensitive skin by avoiding detergent overdosing.

• Before you use this function, you must adapt the washing machine

to the dosing amounts which are recommended for the detergents

you use. Also check if your region’s water hardness corresponds

with the water hardness level “soft” of your washing machine - if

not adapt it.

• Select programme, options and cycle end BEFORE using the

“Dosing Aid” button.

For any details, refer to the separate “Dosing Aid” Instructions for Use.

“DOOR OPEN” INDICATION

Before starting and after end of a programme, the lamp lights to show

the the door can be opened. As long as a wash programme is running,

the door remains locked and must on no account be forced open. In

case you have an urgent need to open it during a running programme,

refer to “Reset” a running programme before the end”.

ECO MONITOR

The “Eco Monitor“ gives you a rough feedback about the power

consumption of the programme setting you selected. As soon as you

turn the programme selector to any programme, the

“

Eco Monitor“ is on.

The indicator on the left is to show that the “Eco Monitor“ is active.

The four indicators next to it show the degree of consumption: the less

power your programme setting is forecasted to consume, the less

indicators will light up. This depends on the programme, temperature

and options selected, and also on the size of the wash load. For that

reason, the forecasted degree of power consumption may adapt when

the washing machine detects the wash load.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool DLCE 71469 in the language / languages: English as an attachment in your email.

The manual is 0,98 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool DLCE 71469

Whirlpool DLCE 71469 User Manual - English - 16 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Whirlpool DLCE 71469 Manual

Product: