641529
17
Zoom out
Zoom in
Previous page
1/36
Next page
EN
17
REMOVING THE ACTIVE 0
COMPARTMENT
The Active 0 compartment can be
removed to create more space inside
the refrigerator. In this case proceed as
follows:
- switch o the compartment
- pull out the drawer
- pull out the glass shelf below Active 0
- remove the white plastic insulation
form the glass shelf
- put back the glass shelf.
Note: the upper shelf and the side supports
cannot be removed.
To restore Active 0 compartment box
operation, make sure you .replace the
white plastic shelf underneath the
box (with the glass shelf assembled
into the plastic) before
inserting the drawer
and reactivating the
function. The Active 0
compartment satisfies
the requirements of
a chill compartment
according to EN 62552.
Clean the compartment and all its parts
regularly, using a cloth and a solution
of warm water and neutral detergent
specifically formulated for refrigerator
interiors (take care not to immerse
the white plastic shelf underneath the
compartment in water).
Before cleaning the box (including
the outside), remove the drawer so
as to disconnect the box from the
electricity supply.
Never use abrasive detergents.
ALARM TYPE Signal Cause Cure
Door open
alarm
Door open alarm indicator
remains on, the acoustical
alarm is activated and the
Alarm Indicator blinks.
The Fridge or Freezer door has
remained open for more than 2
minutes.
Close the door or press the
Stop Alarm to mute the
acoustical alarm.
Temperature
alarm
The Temperature display
blinks (°C) and the Alarm
Indicator remains on.
Inside the Freezer the
temperature is not adequate.
Press the Stop Alarm button;
the acoustical alarm stops,
the Temperature Display
(°C) blinks and the Alarm
Indicator remains on until
a temperature < -10°C is
reached.
Antibacterial
filter alarm
The Antibacterial filter
alarm indicator lit on.
Finished the validity of
Antibacterial filter.
Replace the Antibacterial
filter, press the Alarm button
to reset it.
Long black-out
alarm
The Black Out Alarm icon
remains on, the Alarm
indicator blinks.
Prolonged power failure, able to
cause the inside temperature to
increase to 0°C.
Press the Stop Alarm button;
the acoustical alarm stops.
Malfunction The letter “F” blinks on the
display (°C).
Product malfunction. Contact the After-sales
Service.
ALARM TABLE
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool BSNF 9782 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool BSNF 9782 in the language / languages: English as an attachment in your email.

The manual is 6,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool BSNF 9782

Whirlpool BSNF 9782 Quick start guide - English - 4 pages

Whirlpool BSNF 9782 Installation Guide - English - 16 pages

Whirlpool BSNF 9782 Installation Guide - Dutch - 16 pages

Whirlpool BSNF 9782 Installation Guide - French - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info