304153
2
Zoom out
Zoom in
Previous page
1/2
Next page
5019 312 10172
Whirlpool is a registered trademark of Whirlpool USA
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in
the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the “Energy Label” refer to the programme “Cotton 60°C”.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the
water out.
1. Load the machine, close the drum doors and
check that they are properly locked.
2. Add detergents and additives into the dispenser
to no more then the
“MAX”
level mark, as
follows:
Programme with pre and main wash
Main wash programme without prewash
Fabric softeners and conditioners
Chlorine bleach
Stain remover agents
Anti-scale agents (if necessary)
3. Turn the
programme selector knob
to the
desired programme.
4. Turn the
temperature selector knob
to the
desired temperature.
5. Turn the
spin speed selector knob
to the
desired spin speed. If the spin speed “
0
” is
selected, the final spin is cancelled, but not the
intermediate spins. The programme ends with a
drain cycle.
Selecting or deselecting an option can be done at
any time during the programme. The option will
be applied as long as the corresponding
programme phase has not been executed yet.
“Intensive Rinse” button
One rinse cycle is added to ensure a more
intensive rinse.
This option is particularly suitable for areas with
very soft water, washing baby linen and people
with detergents allergies.
“Half Load” button
Can be used for small loads and lightly soiled
laundry.
Reduces the water consumption especially during
the rinses.
CONSUMPTION DATA
Programme
Temperature Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes)
Cotton 90 5.0 63* 1.80 2:05
Cotton 60 5.0 55 0.95 2:05
Cotton 40 5.0 55 0.55 2:05
Mixed Cotton/
Synthetic
60 2.0 56 0.80 1:30
Synthetic 40 2.0 56 0.40 1:30
Delicate 40 1.5 60 0.55 0:45
Wool 40 1.0 60 0.50 0:40
Handwash 30 1.0 60 0.30 0:50
PREPARATION OF WASH CYCLE SELECT THE DESIRED OPTION
“Rinse Hold” button
The laundry remains in the last rinse water
without progressing to the final spin cycle to
avoid creasing and prevent colours from fading.
This option is particularly recommended for the
“Synthetic” , “Delicate” programmes.
This function is particularly useful if you want
to postpone spinning to a later time, or if you
want to drain only.
Note:
the programme selector knob stops on .
Appliance in “Rinse Hold” :
Press the “Rinse Hold” button again: the
programme will terminate automatically with
the selected spin cycle.
If you do not wish to spin the clothes, press the
On/Off
” button , turn the programme
selector knob to the “Drain” programme
and press the “
On/Off
” button again.
Turn on the tap and press the “
On/Off
” button .
The indicator light of the “
On/Off
” button
lights up.
Note
: If there is a power interruption or if the
appliance is disconnected during the cycle, the
programme will run again from the point where it
was interrupted.
The programme selector knob is in the Stop
position.
1. Press the “
On/Off
” button to switch off the
machine.
2. Cancel the options.
3. Turn the tap off.
4. Wait for the lid to unlock (about 1 minute).
5. Open the lid and the drum doors and unload
the machine.
1. Switch off the machine by pressing the
On/Off
” button .
2. Select the new programme.
3. Start programme by pressing the “
On/Off
button again.
If, for any reason, you wish to interrupt the
programme for a certain time and continue it later:
1. Press the “
On/Off
” button .
2. After the desired pause, press again the
“On/Off”
button .
1. Switch off the machine by pressing the
On/Off
” button .
2. Set the programme selector to “Drain” .
3. Press the “
On/Off
” button again to start
the “Drain” programme .
PROGRAMME START
END OF WASH CYCLE
CHANGE THE PROGRAMME DURING THE WASH
CYCLE
PAUSE/INTERRUPT A PROGRAMME
CANCEL PROGRAMME
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool awt 4103 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool awt 4103 in the language / languages: English as an attachment in your email.

The manual is 0,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool awt 4103

Whirlpool awt 4103 User Manual - English - 15 pages

Whirlpool awt 4103 Quick start guide - German - 2 pages

Whirlpool awt 4103 User Manual - German - 18 pages

Whirlpool awt 4103 User Manual - Dutch - 14 pages

Whirlpool awt 4103 Quick start guide - French - 2 pages

Whirlpool awt 4103 User Manual - French - 15 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info