578849
6
Zoom out
Zoom in
Previous page
1/12
Next page
6
WASSERZULAUFSCHLAUCH ANSCHLIESSEN
CONNECT THE WATER SUPPLY INLET HOSE!
BRANCHEZ LE TUYAU D’ARRIVÉE D’EAU !
SLUIT DE WATERTOEVOERSLANG AAN!
COLLEGARE IL TUBO DI ALIMENTAZIONE DELL’ACQUA!
Sollte der Wasserzulaufschlauch unmontiert sein, muß er am Gerät angeschraubt werden.
If the water inlet hose is not already installed, it must be screwd to the appliance.
Si le tuyau d’arrivée d’eau n’est pas déjà en place, il doit être relié à la machine.
Als de watertoevoerslang nog niet geïnstalleerd is, moet hij aan het apparaat worden geschroefd.
Se il tubo di alimentazione dell’acqua non è già installato, deve essere avvitato alla lavatrice.
Wasserzulaufschlauch von Hand am Wasserhahn anschrauben.
Achtung:
Den Schlauch niemals knicken!
Die Waschmaschine
darf nicht
an die Mischbatterie eines drucklosen
Heißwasseraufbereiters angeschlossen werden.
Drehen Sie den Wasserhahn ganz auf und überprüfen Sie alle Anschlüsse auf
ihre Dichtheit.
Falls Schlauchlänge nicht ausreicht, vorhandenen Schlauch durch einen
ausreichend langen Druckschlauch (mindestens 1000 kPa - freigegeben nach
EN 50084) ersetzen.
Zulaufschlauch regelmäßig auf Sprödigkeit und Risse prüfen und ggf. auswechseln.
Die Waschmaschine kann ohne Rückflussverhinderer angeschlossen werden.
Für Modelle mit Wasserstoppschlauch:
Falls die Schlauchlänge nicht ausreicht, diesen durch einen drei Meter langen
Wasserstoppschlauch (beim Kundendienst oder im Fachhandel erhältlich) ersetzen.
Dieser Austausch darf nur von einem Elektrofachmann vorgenommen werden.
Im Zulaufschlauch und im Kunststoffgehäuse am Wasseranschluss sind je nach
Ausstattung elektrische Bauteile enthalten.
Deshalb den Schlauch nicht durchschneiden
und das Kunststoffgehäuse nicht in Wasser tauchen
. Bei beschädigtem Schlauch die
Waschmaschine sofort vom Netz trennen.
Screw by hand the inlet hose
onto the tap tightening the nut.
Attention:
no kinks in the hose!
The appliance
must not
be connected to the mixing tap of an un-pressurized
water heater.
Check water-tightness of connections by turning the tap completely on.
If the hose is too short, replace it with a suitable length of pressure resistant hose
(1000 kPa min, EN 50084 approved type).
Check the inlet hose regularly for brittleness and cracks and replace if necessary.
The washing machine can be connected without a non-return valve.
For models with Water Stop hose:
If the flexible hose is too short, replace it with a 3 m Water Stop hose (available from After-Sales
Service or from your dealer). This replacement is only to be carried out by a trained electrician.
Depending on the model, the inlet hose and the plastic enclosure at the tap connection contain
electrical components.
Do not cut the hose and do not immerse the plastic enclosure in
water
. Isolate the appliance from the mains immediately if the hose is damaged.
Vissez à la main le tuyau d’arrivée d’eau
sur le robinet en serrant l’écrou.
Attention :
Veillez à ce que le tuyau ne soit pas plié !
L’appareil
ne doit en aucun cas
être connecté au mitigeur d’un chauffe-eau
non pressurisé.
Vérifiez l’étanchéité des raccordements en ouvrant le robinet à fond.
Si le tuyau n’est pas suffisamment long, remplacez-le par un tuyau de longueur
suffisante résistant à la pression (minimum 1000 kPa - en conformité avec EN 50084).
Vérifiez régulièrement que le tuyau d’arrivée d’eau ne présente ni signes de
fragilisation, ni fissures. Le cas échéant, remplacez-le.
8
9
10600793.fm Page 6 Friday, February 10, 2006 10:12 AM
Black process 45.0° 100.0 LPI
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool AWO 6126 W at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool AWO 6126 W in the language / languages: English, German, Dutch, French, Italian as an attachment in your email.

The manual is 0,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool AWO 6126 W

Whirlpool AWO 6126 W User Manual - English - 13 pages

Whirlpool AWO 6126 W User Manual - English - 14 pages

Whirlpool AWO 6126 W User Manual - German - 13 pages

Whirlpool AWO 6126 W User Manual - Dutch - 13 pages

Whirlpool AWO 6126 W User Manual - French - 13 pages

Whirlpool AWO 6126 W User Manual - Italian - 13 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info