315448
2
Zoom out
Zoom in
Previous page
1/2
Next page
5019 312 10771
CONSUMPTION DATA
Whirlpool is a registered trademark of Whirlpool USA.
Add detergent as indicated an the front page and as
described in the chapter “Detergent and Additives” in
your Instructions for Use.
1. Turn the programme selector to the desired
programme. The display shows the programme
duration in hours and minutes as well as the
predefined temperature. The “Start/Pause” button
flashes.
2. The temperature can be altered by pressing the
“Temperature” button.
3. The indication lamp of the predefined spin speed
lights up; in case you want to set another spin speed,
press the “Variable spin” button.
ADD DETERGENTS, CLOSE THE LID AND
SELECT THE PROGRAMME
“DOOR OPEN” INDICATION
Before starting and after end of a programme, the lamp
lights to show the the lid can be opened. As long as a
wash programme is running, the lid remains locked and
must on no account be forced open. In case you have
an urgent need to open it during a running programme,
refer to “Cancel a running programme before the end”.
RED INDICATIONS
“Service”
Lighting up of the “Service” indication can be caused
by a fault in an electrical component. Refer to the
“Troubleshooting Guide” in your “Instructions for Use”;
if the fault persists, contact our After Sales Service.
Water tap closed”
The appliance has no or insufficient water supply. Open
the water tap: if the indications still lights up, refer to the
“Troubleshooting Guide” in the Instructions for Use.
“Clean pump”
Waste water is not pumped out. Check whether the
drain hose is kinked or the filter must be cleaned: in the
latter case refer to the Instructions for Use (“Removing
the Filter”).
Add an appropriate amount of in-wash additive for
stain removal (powder) to the main wash chamber,
together with your detergent (only use powder
detergent with this option). Respect the
manufacturer’s dosing instructions.
Prolongs the programme by approx. 5 to 15 minutes.
Appropriate for use of stain removers and bleaches
on oxygen basis.
Chlorine or perborate bleaches
must not be used!
“Prewash” button
Only for heavily soiled loads (for example sand,
granular dirt) sensible. Increases the cycle time by
approximately 15 min.
Do not use liquid detergent for the main wash when
activating the Prewash option.
“Intensive Rinse” button
More water is added and rinse cycle is prolonged.
This option is particularly suitable for areas with very
soft water, washing baby linen and helping people
with allergies.
“Rinse Hold” button
The laundry remains in the last rinse water without
progressing to the final spin cycle to avoid creasing
and prevent colours from changing.
This option is particularly recommended for the
programmes “Synthetics”, “Daily load” and “Delicates”.
It is particularly useful if you want to postpone
spinning to a later time, or if you want to drain only.
If you select “Rinse Hold”, do not leave items to
soak for too long.
Note: The programme stops to “Rinse hold” at the
time the “Rinse hold” light in the programme
sequence indicator is on. The indication lamp next to
the “Start/Pause”
button flashes.
Terminate the “Rinse Hold” option:
Press the “Start/Pause” button; the programme
will terminate automatically with the final spin cycle
for the present wash programme.
PROGRAMME START
Open the tap and press the “Start/Pause” button.
The indication lamp next to the “Start/Pause” button
lights up. The programme sequence indicator shows
the current programme phase, running from left to right
through Wash, Rinse, Spin/Drain.
The display shows the remaining programme time. Due
to variations in load and temperature of inlet water, the
remaining time is newly calculated in certain programme
phases. If this is the case, an animation appears on
the time display.
PROGRAMME END
All the lights of the programme sequence indicator
are off, and the “Door open” indication lights up.
1. Turn the programme selector to the “Off/O”
position.
2. Close the water tap.
3. Open lid and drum and unload the machine.
4. Leave the lid open for some time to allow the
interior of the machine to dry.
CHANGE PROGRAMME AND/OR OPTIONS
AFTER PROGRAMME START
1. Press the “Start/Pause” button to pause the
programme. The light flashes.
2. Select the new programme, temperature, any
options and another spin speed if you want.
3. Press the “Start/Pause” button again. The new
programme continues at the same position where
the previous programme was interrupted. Do not
add detergent for this programme.
CANCEL A RUNNING PROGRAMME BEFORE
THE END
The “Reset” button cancels a programme before the
end.
Press the “Reset” button for at least 3 seconds;
rES” appears on the display. Any existing water is
drained out before the lid can be opened.
SELECT ANY DESIRED OPTION
Push the button(s) of any option(s) desired - the
respective indication lights up.
When the combination of programme and additional
option(s) is not possible, the indication lights switch off
automatically. Unsuitable combinations of options are
deselected automatically.
“Eco” button
With modified temperature profile and a slightly
prologned washing duration, the optimum
combination of excellent washingresult and even
lower energy consumption is achieved.
“Clean+” button
Choose this option if you use an in-wash additive for
stain removal (powder, for example “Vanish”) - it
will optimize the additive’s efficiency to get better
wash performance and stain removal.
Selectable for programmes “Cotton” and
“Synthetics”; choose temperature of 30 or 40°C and
use with maximum load.
START DELAY
The “Start delay” button allows to run the machine at
the consumer's convenience, for example at night when
electricity is cheaper. Do not use liquid detergent when
activating the “Start delay”.
Select programme, temperature and options.
Press the “Start Delay” button to select the delay
time up to 23 hours;
Press the “Start/Pause” button.
The indication light over the “Start delay” button
flashes and the countdown of the delay time begins.
The dot between hours and minutes of the delay
time indicated flashes.
The time delay indication disappears when the
programme starts and it is replaced by the remaining
programme time.
Once having pressed the “Start/Pause” button,
the number of hours preselected can be reduced by
pressing and holding the “Start delay” button. From
1 hour on, the delay time can also be reduced in
steps of 10 minutes.
To cancel the “Start delay
..before you press the “Start/Pause” button:
Turn the programme selector to another position
or press the “Reset” button.
..after having pressed the “Start/Pause” button:
Press the “Reset” button for at least 3 second - the
start delay time dissapears from the time display.
If you do not wish to spin the clothes, turn the
programme selector knob to the “Drain
programme and press the “Start/Pause” button.
Variable spin” button
Every programme has a predefined spin speed.
Press the button to set another spin speed.
If spin speed “0” is selected, the final spinning is
cancelled but intermediate spin peaks remain during
the rinse. The water is drained out only.
Programme
Temperature
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration*
(hours : minutes)
White Cotton / Antibacterial 95 6.0 59** 1.90 2:00
Cotton 60 6.0 55 1.14 2:30
Cotton with Eco*** 60 6.0 55 0.90 3:30
Cotton 40 6.0 55 0.70 2:30
Synthetics 60 3.0 54** 0.90 1:40
Synthetics 40 3.0 48 0.55 1:25
Daily load 40 3.0 40 0.45 1:00
Speed 15’ 30 3.0 30 0.15 0:15
AquaEco 40 2.5 19 0.45 1:00
Jeans 40 5.0 70 0.70 2:43
SuperEco 60 6.0 55 0.78 4:00
Delicates 40 1.5 50 0.55 0:45
Wool
40 1.0 55 0.55 0:45
Handwash 40 1.0 40 0.55 0:35
Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the
home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type
of wash.
* The remaining time indicator can deviate from the values in the table, because it takes into account the household conditions applicable
at that time.
** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.
*** Reference Programme for Energy Label.
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool aweco 8844 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool aweco 8844 in the language / languages: English as an attachment in your email.

The manual is 0,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool aweco 8844

Whirlpool aweco 8844 User Manual - English - 15 pages

Whirlpool aweco 8844 User Manual - German - 14 pages

Whirlpool aweco 8844 User Manual - Dutch - 14 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info