539834
2
Zoom out
Zoom in
Previous page
1/19
Next page
GB 2
DEFINITION OF USE
This washing machine is exclusively destined to wash
machine washable laundry in quantities which are usual
for private households.
Observe the instructions given in these Instructions
for Use and the Programme Chart when using the
washing machine.
Keep these Instructions for Use and the Programme
Chart; if you pass on the washing machine to
another person, also give him/her Instructions for
Use and Programme Chart.
BEFORE USING THE WASHING MACHINE
1. Remove the packaging and check
a.
Cut and remove the shrink-wrap.
b.
Remove the top protection and the protective
corners.
c. Remove the bottom protection by tilting and
turning the washing machine on one rear
bottom corner. Make sure that the black
plastic part of the bottom protection (if
available on the model) remains in the packing
and not in the machine bottom.
This is important, as otherwise the plastic part could
damage the washing machine during operation.
d.
Open the lid by pressing it slightly down while
raising the handle. Remove the polystyrene cushion
(depending on model).
e.
Remove the blue protective film from the panel
(depending on model).
After unpacking, make sure that the washing machine is
undamaged. If in doubt, do not use the washing machine.
Contact After-Sales Service or your local retailer.
Keep the packaging materials (plastic bags,
polystyrene parts, etc.) out of reach of children;
they are potentially dangerous.
If the appliance was exposed to the cold prior to
delivery, keep it at room temperature for a few
hours before operating.
2. Remove the transport bracket
The washing machine is fitted with transport screws
and a transport bracket to prevent damage during
transport.
Before using the washing machine
you must remove the transport bracket
(see
“Installation”/“Removal of transport bracket”).
3. Install the washing machine
Place the washing machine on a flat and stable floor
surface.
Adjust the feet to ensure that the machine is stable
and level (see “Installation”/“Adjust the feet”)
.
In case of wooden or so-called “floating floors” (for
instance certain parquet or laminate floors), place
the appliance on a 40 x 60 cm sheet of plywood at
least 3 cm in thickness which is secured to the floor.
Make sure that the ventilation openings in the base
of your washing machine (if available on your model)
are not obstructed by a carpet or other material.
4. Water supply
Connect the water supply inlet hose in accordance
with the regulations of your local water company
(see “Installation”/“Connect the water inlet hose”).
Water supply: Cold water only
Tap: 3/4” threaded hose connection
Pressure: 100-1000 kPa (1-10 bar).
Only use new hoses for connecting the washing
machine to the water supply. Used hoses must not
be used anymore and should be discarded.
5. Drain hose
Connect the drain hose to the siphon or hook it
over the edge of a sink with the “U” bend (see
“Installation”/“Connect the water drain hose”).
If the washing machine is connected to a built-in
drainage system, ensure the latter is equipped with
a vent to avoid simultaneous loading and draining of
water (siphoning effect).
6. Electrical connection
Electrical connections must be carried out by a
qualified technician in compliance with the
manufacturer’s instructions and the current
standard safety regulations.
The technical data (voltage, power and fuses) are given
on the rating plate on the rear of the washing machine.
The washing machine must be connected exclusively by
means of a socket with an earth connection in
accordance with current regulations. The washing
machine must be earthed by law. The manufacturer
declines all liability for injury to persons or animals or
damage to property deriving directly or indirectly from
failure to observe the directions.
Do not use extension leads or multi sockets.
Before any maintenance on the washing machine
disconnect it from the mains supply.
Access to the mains plug or to disconnection from the
mains supply via a double-pole switch must be ensured
at all times following the installation.
Do not operate the washing machine if it has been
damaged during transport. Inform the After-Sales Service.
Mains cable replacement is only to be carried out by
After-Sales Service.
The washing machine must be connected to an effective
earthing installation, in compliance with the regulations
in force. In particular, washing machines installed in
premises containing a shower or a bath must be
protected by a differential residual current device of at
least 30 mA. Earthing the washing machine is obligatory
under the law. The manufacturer declines all liability for
injury to persons or animals or damage to property
deriving either directly or indirectly from failure to
observe the directions in these Instructions for Use.
The washing machine may only be used in the
household for the prescribed uses.
Dimensions:
Width: 400 mm
Height: 900 mm
Depth: 600 mm
IFU-TL HR GB.fm Page 2 Friday, November 7, 2008 2:30 PM
Black process 45.0° 100.0 LPI
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool AWE 5115 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool AWE 5115 in the language / languages: English as an attachment in your email.

The manual is 1,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool AWE 5115

Whirlpool AWE 5115 Quick start guide - English - 2 pages

Whirlpool AWE 5115 User Manual - English - 4 pages

Whirlpool AWE 5115 Quick start guide - German - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info