306062
4
Zoom out
Zoom in
Previous page
1/14
Next page
20
WATER SUPPLY
Water supply: cold water only
Tap: 3/4 threaded hose connection
Pressure: 10-100 N/cm² (1-10 bar).
Should the appliance be installed in a room
which is subject to extremely low temperatures,
you need to empty water at the end of each wash
programme. Please follow the instructions given
in the chapter titled Draining Residual Water
and disconnect the water inlet hose.
WATER INLET HOSE(S)
1.
The mesh filter supplied with the appliance
must be inserted in the connection between
the supply hose and the tap.
2.
Carefully screw the hose connection to the
tap preferably by hand. Make sure there are
no kinks in the hose and that it is not crushed.
3.
Check water-tightness of tap and appliance
connections by turning the tap completely on.
If the hose is too short, replace it with a
suitable length of pressure resistant hose
(10 bar min., EN 50065 approved type).
The appliance can be connected without a
non-return valve.
Install the appliance in accordance with
regulations of your local water company.
For Great Britain & Ireland only:
Water inlet:
- hot (see
A
) fill hose;
- and cold (see
B
) fill hose.
The warm water inlet temperature must not
exceed 60° C.
WATER STOP ANTI-FLOODING SYSTEM
(depending on model)
:
Screw the threaded connection with the filter
into the union nut on the water tap. Open the
water tap fully and check the water tightness
of the connection point.
The appliance must not be connected to the
mixing tap of a non-pressurized water heater!
The inlet hose (see arrow
C
) and the plastic
enclosure at the tap connection contain
electrical components.
Do not cut the hose and do not immerse the
plastic enclosure in water.
If the flexible hose is damaged, unplug the
appliance from the mains immediately.
If the hose is too short, replace it with a 3 m Water
Stop hose (available from After-Sales Service or
from your dealer). This operation must be carried
out exclusively by a licensed electrician.
INSTALLATION INSTRUCTIONS
C
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool awa 1004 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool awa 1004 in the language / languages: English as an attachment in your email.

The manual is 0,52 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info