314334
2
Zoom out
Zoom in
Previous page
1/2
Next page
5019 312 00060
Whirlpool is a registered trademark of Whirlpool USA.
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in
the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the Energy Label refer to the programme Cotton 60°C.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains
the water out.
1. Load the machine, close the drum flaps and
check that they are properly locked.
2. Add detergents and additives into the dispenser
to no more then the
MAX
level mark, as
follows:
Programme with pre and main wash
Main wash programme without prewash
Fabric softeners and conditioners
Chlorine bleach
Stain remover agents
Anti-scale agents (if necessary)
3. Turn the
programme selector knob
to the
desired programme.
4. Turn the
temperature selector knob
to the
desired temperature.
5. Turn the
spin speed selector knob
to the desired
spin speed. If the spin speed 0 is selected, the final
spin is cancelled, but not the intermediate spins. The
programme ends with a drain cycle.
Selecting or deselecting an option can be done at
any time during the programme. The option will
be applied as long as the corresponding
programme phase has not been executed yet.
Express button
For fast, energy saving wash cycles.
Ideally suited for small loads consisting of lightly
soiled laundry.
Rinse Hold button
The laundry remains in the last rinse water
without progressing to the final spin cycle to
avoid creasing and prevent colours from fading.
This option is particularly recommended for the
Synthetic or Delicate programmes.
This function is particularly useful if you want to
postpone spinning to a later time, or if you want
to drain only.
Remark:
the programme selector knob stop on ““.
Appliance in Rinse Hold:
Press the Rinse Hold button again: the
programme will terminate automatically with the
selected spin cycle.
If you do not wish to spin the clothes, press the
On/Off
button, turn the programme selector
knob to the Drain programme and press the
On/Off
button again.
CONSUMPTION DATA
Programme
Temperature Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes)
Cotton 90 5.0 63* 1.80 2:05
Cotton 60 5.0 55 0.95 2:05
Cotton 40 5.0 55 0.55 2:05
Synthetic 60 2.0 56 0.80 1:35
Synthetic 40 2.0 50 0.40 1:30
Delicate 40 1.5 60 0.55 0:50
Wool 40 1.0 60 0.50 0:40
Silk 30 1.0 60 0.30 0:50
PREPARATION OF WASH CYCLE
SELECT THE DESIRED OPTION
Turn on the tap and press the
On/Off
button. The
indicator light of the
On/Off
button lights up.
Note
: If there is a power interruption or if the
appliance is disconnected during the cycle, the
programme will run again from the point where it was
interrupted.
The programme selector knob is in the Stop
position.
1. Press the
On/Off
button to switch off the
machine.
2. Cancel the options.
3. Turn the tap off.
4. Wait for the door to unlock (about 1 minute).
5.
Open the door and the drum flaps and unload
the machine.
1. Switch off the machine by pressing the
On/
Off
button.
2. Select the new programme.
3.
Start programme by pressing the
On/Off
button again.
If, for any reason, you wish to interrupt the
programme for a certain time and continue it later:
1. Press the
On/Off
button.
2. After the desired pause, press again the
On/
Off
button.
1. Switch off the machine by pressing the
On/
Off
button.
2. Set the programme selector to Drain.
3. Press the
On/Off
button again to start the
Drain programme.
PROGRAMME START
END OF WASH CYCLE
CHANGE THE PROGRAMME DURING THE WASH
CYCLE
PAUSE/INTERRUPT A PROGRAMME
CANCEL PROGRAMME
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool awa 1002 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool awa 1002 in the language / languages: English as an attachment in your email.

The manual is 0,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool awa 1002

Whirlpool awa 1002 User Manual - English, Dutch, Turkish - 13 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info