342013

Whirlpool art 686 m ja Manual

8
Zoom out
Zoom in
Previous page
1/28
Next page
38
INSTALLATION (FOR 60 cm DEEP MODELS ONLY)
INSTALLATION
(FOR ALL MODELS GREATER THAN 60 cm DEEP)
6.
Adjust the front leveling bolt to bring the refrigerator top
parallel with the cabinet above the refrigerator. Leave
approximately 3.18 mm gap between the top hinges and the
cabinet. If you do not have a cabinet above the refrigerator,
simply adjust the refrigerator to make it level.
7.
Adjust the rear leveling bolt to bring the refrigerator level
with the side cabinets or cabinet end panels.
8.
If you want, you may now use the four leveling bolts to raise
the refrigerator to close the gap between the refrigerator top
hinge and the cabinet opening. Check that all four rollers still
touch the floor and that the cabinet doors above the
refrigerator open all the way.
NOTE
: Cabinets with full-overlay doors will require 6.35 mm
additional clearance between the top hinge and cabinet to
prevent the doors from hitting the hinge when opening. If you
have a trim panel kit on the refrigerator doors, 19.05 mm
additional clearance is needed to prevent the cabinet doors
from hitting the refrigerator door trim.
9.
Replace the base grille.
Leveling
If necessary, it is possible to level the appliance from side to
side by turning the two levelling screws right behind the front
grille on the refrigerator bottom, one on the right and the other
on the left, proceeding as follows:
•
remove the front grille;
•
turn one screw or both, clockwise to raise the appliance;
•
turn one screw or both, anticlockwise to lower the appliance;
•
check if the desired levelling has been reached;
•
put the front grille back into place.
Removal of the front grille
To remove the grille:
•
open both doors (refrigerator and freezer);
•
pull out the grille frontally to release it from the metal retainers.
At this point it is possible to reach the defrost pan for
periodic cleaning, proceeding as follows:
•
remove the defrost pan;
•
wash the defrost pan with warm water and sodium
bicarbonate;
•
rinse and dry;
•
put the defrost pan back into place with the notched corner
to the rear;
•
make sure that the defrost drain tube is pointing into the pan;
•
put the front grille back into place.
1.
Leave 3.18 mm minimum
clearance for leveling the
refrigerator. Leave 6.35 mm
minimum clearance is you have
full-overlay cabinet doors.
2.
Front of the refrigerator.
3gb33001.fm5 Page 38 Monday, August 20, 2001 3:48 PM
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool art 686 m ja at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool art 686 m ja in the language / languages: English, Dutch as an attachment in your email.

The manual is 0,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info