360684
10
Zoom out
Zoom in
Previous page
1/11
Next page
83
TROUBLESHOOTING GUIDE
AFTER-SALES SERVICE
Before contacting After-Sales Service:
1.
See if you can solve the problem yourself with the
help of the “Troubleshooting guide”).
2.
Switch the appliance on again to see if the
problem has been solved. If it has not, disconnect
the appliance from the power supply and wait for
about an hour before switching on again.
3.
If the problem persists after this course of action,
contact After-sales Service.
Specify:
the nature of the problem,
the model,
the Service number (the number after the word
SERVICE on the data plate on the inside of the
appliance),
your full address,
your telephone number and area code.
Note:
The direction of door opening can be changed.
If this operation is performed by After-sales
Service it is not covered by the warranty.
Defect Probably cause Solution
1.The appliance is not working
Lack of power supply.
Check electric set.
Check properly inserted plug in the socket.
In case of lack of power supply. You need call
for electrician.
Burn fuse (safety device). Replace fuse (safety device).
Thermostat knob set to “Off” or
“0”.
Set the temperature in chosen position
according to product sheet.
2.Temperature inside the
compartments too high.
Doors aren’t closed properly or
gasket uncorrecty adhered.
Check if it is possibility to closure doors.
Check if gasket is clear and undamage.
Improper set thermostat knob.
Set thermostat knob in chosen position
according to product sheet.
Improper appliance installed.
Check if the appliance is installed near heat
source.
3.Water collects at the bottom of
the refrigerator or freezer
compartment (depends on model).
Drain of defrost water is blocked.
Clear drain. (it is placed over the compressor
or in the middle of drip channel of
refrigerator).
Improper setting food. Food shouldn’t touch back wall of cabinet.
4.The inside light is not working
Lack of power supply. See point 1.
Bulb burnt out.
Disconnect the appliance from mains power
supply. Remove the bulb cover. Check the bulb
and if necessary replace it. Replace using
maximum 15W bulb.
In some models a special bulb is used. Bulb
change instruction is put in the chart.
5.The appliance is excessively
noisy.
The appliance is wrong set.
Check level of appliance
(adjustment front stems)
Check if the appliance isn’t in contact with
other furniture or objects.
6. Noise from expanding
Noises due to expansion in the
refrigerant circuit.
Normal effect correctly.
7. The front edge of the appliance
maybe hot.
Normal effect – prevent the formation of
condensation water.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool arc 7412 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool arc 7412 in the language / languages: English as an attachment in your email.

The manual is 0,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info