515822
16
Zoom out
Zoom in
Previous page
1/26
Next page
44
TROUBLESHOOTING
Warning:
Do not attempt to repair the air conditioner yourself. Incorrect repairs may cause electrocution or fire,
so please contact the Whirlpool Authorized Service Center nearest you for professional repairs.
The following checks may save your time and costs.
Malfunction Cause
Air conditioner does not start
immediatly after a stop.
To protect the air conditioner when started after a stop, the
microcomputer control delays for 3 minutes before allowing the
air conditioner to start.
An unpleasant odor is perceived
at startup
The air conditioner itself is odorless. Any odor is accumulated
from the environment. The solution is to clean the air filter (see
page 42).
If there is still any problem, the air conditioner should be cleaned
(Please contact the Whirlpool Authorized Service Center).
You may hear a “gurgling” noise
when the air conditioner is on
When the air conditioner is started, or the compressor starts or
stops while running, or the air conditioner is stopped, you may
hear a gurgling noise that is the refrigerant flowing back and is not
a malfunction.
A thin fog may flow from the
outlet when the air conditioner is
running in cooling mode.
This may occur when the indoor temperature and humidity are
high. This is because the indoor air is cooled quickly.
After a short time, the fog will disappear as the indoor
temperature and humidity decrease
You may hear a slight crack when
the air conditioner is started or
stopped
This is the sound of friction caused by expansion of the front panel
or other parts due to the change of temperature
Air conditioner does not run.
Is there a power failure?
Is the power plug loose in the socket?
Has the circuit protection device been tripped?
Is the voltage too high or too low? (see page 46 - have it tested by
a professional).
Has the timer function been used correctly? (see page 39)
The air conditioner is not cooling
(or heating) properly
Is the temperature setting correct? (see page 38)
Is the air intake or outlet of the outdoor unit blocked?
Is the air filter clogged by dust? (see page 42)
Are all the doors and windows closed
Is the air flow set to “LOW FAN”?
Is there another heat source in the room?
Remote control cannot execute
control
The remote control sometimes cannot execute control if the air
conditioner is subject to abnormal interference or frequent switch
of functions. To resume normal operation, switch off and on again
properly.
Is the remote control in range and not blocked by any obstacles?
Check the battery in the remote control. If low, replace the
battery. (see Page 41)
Check the remote control for damage
Water leaks from indoor unit
High air humidity
Condensation overflow
Joint of indoor unit drain pipe is loose
Water leaks from outdoor unit
In cooling mode, water may condense on pipe or pipe joint due to
cooling.
Defrost water flows out in heating or defrost (auto defrost) mode
In cooling mode, water from heat exchanger may leak
32602005GB.fm Page 44 Thursday, December 14, 2006 11:24 AM
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool AMC 990 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool AMC 990 in the language / languages: English as an attachment in your email.

The manual is 4,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool AMC 990

Whirlpool AMC 990 User Manual - German - 25 pages

Whirlpool AMC 990 User Manual - Dutch - 25 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info