The instructions below, to be carried out in the order in which they are numbered, refer to the gures (with the same step numbers) given on the last pages of
this manual.
1.Prepare the cut-out on the back of the wall unit, corresponding to the overall dimensions of the hood
60 cm = 260X493
90 cm = 260X693
2.Prepare the hole at the top for the exhaust pipe Ø150
3.Fit the exhaust pipe connector (using the two 3.5x9.5 screws provided)
4.Remove the protective lm from the lateral adhesive strips
5.Slide the hood inside the wall unit
6.The lateral snap-in supports will return to the outside, allowing to fasten the hood to the wall unit
7.Secure the xing by tting n°.4 screws (two each side) to each side support:
16mm screw, for wall units 15 to 20mm thick,
12mm screw for wall unit above 20mm thick
Note: when fastening, apply a light pressure on the hood body, in order to facilitate the lateral adhesive gripping
8.Fit n°.4 screw caps
9.Connect the hose (to be purchased separately) for venting the exhaust fumes; if necessary, use the multi-connection ange to reduce the aperture to
ø125-120
For Extractor Version only: feed the hose towards the exterior
For lter versions only: t the ow-diverter grille (to be purchased separately) to the top of the of the wall unit
10.Open the perimeter extraction panel and remove the grease lter,
11.For lter version only: insert the carbon lters (refer to instructions in the section MAINTENANCE-Carbon Filter)
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Whirlpool AKR860 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Whirlpool AKR860 in the language / languages: English as an attachment in your email.
The manual is 1,82 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
