5019 318
33135
AKR 641 - AKR 643
1.
Control panel.
2.
Grease filter (1 or 2 pieces depending on model).
3.
Grease filter spring release handles.
4.
Lighting unit.
5.
Pull-out steam deflector.
6.
Extractor unit body.
Removing and/or washing the grease filter/s
1.
Disconnect the electrical power supply.
2.
Remove the dirty grease filter/s by pulling the handle
first backwards and then downwards (
Fig. 1
).
3.
After cleaning the grease filter refit in reverse order,
making sure the entire extraction surface is covered.
Replacing bulbs
1.
Disconnect the electrical power supply.
2.
Use a small screwdriver or any other suitable tool to
prise off the lamp cover (
Fig. 2
).
3.
Remove the burnt-out bulb.
4.
Replace using 40 W max E14 bulbs only.
5.
Replace the lamp cover so that it clicks into position.
Fitting or renewing the carbon filter:
1.
Disconnect the electrical power supply.
2.
Remove the grease filter/s (
Fig. 1
).
3.
If the carbon filters are already mounted (one or two
filters, depending on the model. covering the motor
protection grille) and need renewing, turn the central
handle (
Fig. 3 - c
) anticlockwise until the filters release.
4.
If the carbon filters are not already mounted, locate the
filters to cover the motor protection grilles (two
protection grilles - two carbon filters, one protection
grille - one carbon filter), then turn the central handle
(
Fig. 3 - c
) of the filters clockwise.
5.
Refit the grease filter/s (
Fig. 1
).
CONTROL PANEL
Light switch.
The switch has two positions (lights OFF - lights ON).
To switch on the lights: move the switch to the right.
Motor switch.
The extraction speed switch has 3 settings, depending
on the amount of steam and fumes.
To increase the extraction speed: move the switch to
the right.
