5019 318
33111
AKR 604-605-606-650
AKR 769-770-771-772-773
D F NL E
GB
P I GR
PRODUCT SHEET
1.
Control panel.
2.
Grease filters (1 or 2 pieces).
3.
Lighting unit (AKR 772-773: halogen bulbs).
4.
Grease filters surround.
Removing and renewing or cleaning the
grease filter:
1.
Disconnect the electrical power supply.
2.
Remove the dirty grease filter by pulling the handle
first backwards and then downwards (
Fig. 1
).
3.
After cleaning the grease filter refit in reverse
order, making sure the entire extraction surface is
covered.
Replacing bulbs
1.
Disconnect the electrical power supply.
2.
Remove the grease filter (
Fig. 1
) and the grease
filter surround (
Fig. 2
- sequence
a-b
).
3.
Remove the burnt-out bulb.
4.
Use 40 W max E14 bulbs only.
For models AKR 772-773 use 20 W max halogen
bulbs (GU5.3 - Ø 50 mm).
5.
Remount the grease filters surround.
Fitting or renewing the carbon filter:
1.
Disconnect the electrical power supply.
2.
Remove the grease filter (
Fig. 1
) and the grease
filter surround (
Fig. 2
- sequence
a-b
).
3.
If the carbon filters are already mounted (one or
two filters, depending on the model. covering the
motor protection grille) and need renewing, turn
the central handle (
Fig. 3 - c
) anticlockwise until
the filters release.
4.
If the carbon filters are not already mounted,
locate the filters to cover the motor protection
grilles (two protection grilles - two carbon filters,
one protection grille - one carbon filter), then turn
the central handle (
Fig. 3 - c
) of the filters
clockwise.
5.
Refit the grease filter surround and the grease
filter.
CONTROL PANEL
Light switch.
The switch has two positions
(lights OFF - lights ON).
To switch on the lights: move the switch to the
right.
Speed selector switch.
The extraction speed switch has 3 settings,
depending on the amount of steam and fumes.
To increase the extraction speed: move the
switch to the right.
