583544
7
Zoom out
Zoom in
Previous page
1/8
Next page
16
Unpack the appliance and ensure that the
various elements (plastic bags, polystyrene
pieces, etc.) are well out of the reach of
children.
Remove the 4 protection pieces inserted
between lid and appliance (A).
Important
: place two of the four
protection pieces (A), used to protect the
lid during transport, in the capacitor
plastic holder recess on the rear of the
appliance (E).
This operation is necessary in order to
ensure the proper distance of the appliance
from the wall.
Remove the packaging from the bottom
(B) of the freezer.
After connecting the appliance to the
mains, when the right temperature has
been reached (about an hour), ensure that
the fast freeze function is inactive (yellow
LED is off).
During the freezing phase, the lid does
not open until the right temperature has
been reached (about 1 hour).
Ensure that the defrosting water drainage
plug is correctly positioned
(C)
.
Ensure that the lid seal is not damaged: to
remove any deformation, warm the seal with
a hair dryer.
Before connecting the appliance to the mains
supply, ensure that the voltage corresponds
to that given on the rating plate (see figure
below).
After the freezer has been installed, check
that it is not resting on the mains cable.
Install the appliance in a dry, well ventilated
room. Avoid locations near a source of heat
or in direct sunlight.
For optimum appliance operation and in
order to avoid damage when the lid is
opened, leave a space of at least 7 cm from
the rear wall and 7 cm at the sides.
Fit the accessories.
ELECTRICAL CONNECTION
Electrical connections must be made in
accordance with local regulations.
Data regarding voltage and absorbed power
are given on the rating plate on the rear of the
appliance
(D)
.
Regulations require that the appliance is
earthed. The manufacturer declines all
liability for injury to persons or animals
and for damage to property resulting from
failure to observe the above procedures
and reminders.
If the plug and socket are not of the same
type, have the socket replaced by a qualified
electrician.
Do not use extension leads or adaptors.
DISCONNECTING THE APPLIANCE
Electrical disconnection must be possible
either by unplugging the appliance or by
means of a double-pole switch located upline
from the socket.
INSTALLATION
70 m
m
7
0
m
m
70 mm
C
B
A
42000cGB.fm5 Page 16 Monday, May 16, 2005 3:54 PM
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool AFG 6251 AP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool AFG 6251 AP in the language / languages: English as an attachment in your email.

The manual is 0,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool AFG 6251 AP

Whirlpool AFG 6251 AP Quick start guide - English - 2 pages

Whirlpool AFG 6251 AP User Manual - German - 7 pages

Whirlpool AFG 6251 AP Quick start guide - German - 4 pages

Whirlpool AFG 6251 AP User Manual - Dutch - 7 pages

Whirlpool AFG 6251 AP Quick start guide - Dutch - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info