Check the rinse aid level
Mechanical indicator C.
Electric indicator on control panel (if provided).
Check the
salt level
On models with water softener
system only.
Mechanical indicator D.
Electrical indicator light on control
panel
(if present).
Load the racks
Refer to the dishwasher loading instructions.
Select a programme
Press the button until the desired programme lights up.
Select the
required options
If necessary (where present). The corresponding indicator light
illuminates/the display shows the relevant information.
Turn on the tap
water tap, then close
the door to start the
programme
“Cancel”
• Open the door, press until the
indicator lights 4 + 5 (marked by
“end” on the control panel)
illuminate.
• Close the door, after about 1
min. the cycle ends.
“Change programme in
progress”
• Open the door.
• Select another programme and
close the door in order to start
the new cycle. End-of-cycle.
Wash cycle
- Only open the door if necessary
(Warning: steam may escape).
- If the appliance is switched off
during a wash cycle, when
switched on again it will resume
the cycle from the point where it
was interrupted.
Switch off the appliance
At the end of the programme the dishwasher emits a brief audible signal.
Indicator lights 4 + 5 (marked by “end” on the control panel) illuminate.
Open the door and press the On/Off button.
All indicator lights switch off.
Tu r n o f f
the water tap, unload the
dishes from the racks
Warning: be careful opening the door, as steam will escape!
Empty the dishwasher starting from the bottom rack.
NLFGBD
