756765
6
Zoom out
Zoom in
Previous page
1/7
Next page
16
Care and maintenance
Clean the hob after each use in order to avoid damaging the
surface and to prevent the formation of baked-on deposits
which are difficult to remove. Before cleaning, make sure the
cooking zones are switched off and that the residual heat
indicator (“H”) is not displayed.
DO NOT clean the hob with a steam
cleaner!
Periodically check for dust under the
appliance, near the cooling air inlet or the
outlet openings. This could hinder the
ventilation and cooling of the electronic
module and decrease the effectiveness of the
hob.
To clean the hob, proceed as follows:
1. use a soft clean cloth, absorbent kitchen wipes or a
proprietary cleaner for glass ceramic hobs. Do not use
abrasive sponges and/or metal scouring pads.
2. Food spills should be cleaned off before they bake onto
the glass ceramic surface. Sugar and foods with a high
sugar content damage the glass ceramic surface and must
be immediately removed using a scraper for glass. Glass
scrapers must be handled with care.
3. Remove any stubborn food residues with a scraper or
proprietary detergents.
4. Salt, sugar and sand can scratch the glass ceramic hob:
clean up any such spills on the hob immediately.
Troubleshooting Guide
Before contacting After-sales Service:
read and follow the instructions given in the section
“Operating instructions”.
Connect the hob to the electricity supply and check that the
supply has not been shut off.
Clean the hob and dry it thoroughly.
If, when the hob is switched on, alphanumeric codes appear
on the display, consult the following table for instructions.
WARNING! If you are unable to turn the glass-ceramic hob off after using it, disconnect it immediately from
the power supply.
After-sales Service
Before contacting After-sales Service:
Try to solve the problem (see “Troubleshooting Guide”).
Switch the appliance off, wait 30 seconds then switch it on
again. to see if the fault persists.
If after the above checks the fault persists, contact the nearest
After-sales Service.
Always provide:
a brief description of the fault;
the exact type and model;
the service number (number after the word Service on the
rating plate. “See figure in the next page”) is located on the
underside of the cooktop or on the warranty booklet;
your complete address and phone number.
If any repairs are required, please contact an authorized After-
sales Service as indicated in the warranty.
WARNING! Failure to comply with these
instructions may compromise the safety and
quality of the product.
MAINTENANCE
ERROR CODE DESCRIPTION POSSIBLE CAUSES REMEDY
The hob switches off
and after 30 seconds
emits an acoustic signal
every 4 seconds
Continuous pressure on
control panel area Water or utensils on control panel Clean the control panel
C81, C82
The control panel switches off
because of excessively high
temperatures
The internal temperature of
electronic parts is too high
Wait for the hob to cool down
before using it again
F42 or F43 The connection voltage is
wrong
The sensor detects a discrepancy
between the appliance voltage and
that of the mains supply
Disconnect the hob from the
mains and check the electrical
connection
F12, F21, F25, F36,
F37, F40, F47, F56,
F58, F60
Call the After-Sales Service and specify the error code
31902052GB.fm Page 16 Wednesday, September 3, 2008 4:05 PM
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool ACM711 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool ACM711 in the language / languages: English as an attachment in your email.

The manual is 1,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool ACM711

Whirlpool ACM711 User Manual - German - 8 pages

Whirlpool ACM711 User Manual - Dutch - 7 pages

Whirlpool ACM711 User Manual - French - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info