335825
14
Zoom out
Zoom in
Previous page
1/123
Next page
GB14
Timer
The timer can be used to set cooking time for a maximum of 99 minutes (1 hour and 39 minutes) for one cooking zone only.
Select the cooking zone to be used with the timer (an illuminated dot appears to the bottom right hand side of the heat setting indicator on the
display), then set the desired cooking time using the buttons “+” and “-” of the timer function (see figure above). A few seconds after the button
is pressed, the timer begins the countdown (the luminous dot of the selected cooking zone starts flashing). Once the set time has elapsed, an
acoustic signal sounds and the cooking zone switches off automatically.
To deactivate the timer, press the “-” button until the display shows “0:0” or press the “+” and “-” buttons of the timer at the same time.
Important: The timer function can only be used with one cooking zone at a time.
Minute minder
The minute minder can only be used when the hob is not in use and allows a maximum setting of 99 min.
Press the “+” button under the timer indicators: the display shows the minutes ready for setting.
Select the time desired using the buttons + and -.
After a few seconds the minute minder starts to count down. Once the set time has elapsed an acoustic signal sounds.
Important: The minute minder function can only be used when the hob is switched off; if it is then switched on, the minute minder countdown is automatically
cancelled.
Control panel warnings.
Residual heat indicator.
The hob is fitted with a residual heat indicator for each cooking zone. These indicators alert the user when cooking zones are still hot.
If the display shows , the cooking zone is still hot. If the residual heat indicator of a given cooking zone is lit, that zone can be used, for example, to keep a
dish warm or to melt butter.
When the cooking zone cools down, the display goes off.
Incorrect or missing pot indicator.
The hob features an automatic pot detection system for all cooking zones. If no pot is detected, the display with the cooking zone power level indicator
flashes. Make sure the pot is correctly positioned and that it has the characteristics given in the section “Before use”.
IMPORTANT: Do not use abrasive sponges or scouring pads. Their use could eventually ruin the glass.
After each use, clean the hob (when it is cool) to remove any deposits and stains due to food residuals.
Sugar or foods with a high sugar content damage the hob and must be immediately removed.
Salt, sugar and sand could scratch the glass surface.
Use a soft cloth, absorbent kitchen paper or a specific hob cleaner (follow the Manufacturers instructions).
Read and follow the instructions given in the section “Instructions for use”.
Make sure there is not a power outage.
Dry the hob thoroughly after cleaning it.
If, when the hob is switched on, alphanumeric codes appear on the display, consult the following table for instructions.
If the hob cannot be switched off after using it, disconnect it from the power supply.
CLEANING
WARNING - Do not use steam cleaners.
- Before cleaning, make sure the cooking zones are switched off and that the residual heat indicator (“H”)
is not displayed.
TROUBLESHOOTING GUIDE
ERROR CODE DESCRIPTION POSSIBLE CAUSES ERROR ELIMINATION
The hob switches off and after 30 seconds emits
an acoustic signal every 4 seconds.
Permanent pressure on the control
zone
Water or kitchen utensils on the control
zone Clean the control zone
C81, C82
The control panel switches off
because of excessively high
temperatures
The internal temperature of electronic
parts is too high
Wait for the hob to cool down before
using it again.
F42 or F43 The connection voltage is wrong
The sensor detects a discrepancy between
the appliance voltage and that of the
mains supply
Disconnect the hob from the mains
and check the electrical connection
F12, F21, F25, F36, F37, F40, F47, F56, F58, F60 Call the After-Sales Service and specify the error code
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool acm 701 ix at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool acm 701 ix in the language / languages: All languages as an attachment in your email.

The manual is 24,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool acm 701 ix

Whirlpool acm 701 ix User Manual - German - 8 pages

Whirlpool acm 701 ix User Manual - Dutch - 7 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info