When raising the canopy, make sure sensor wire is placed into the cut out notch on the top edge of the canopy. If your canopy does not have a cut
out notch, be sure to use caution when attaching the canopy as the edge of the canopy may cause the sensor wire to be cut. Make sure to mount
the sensor on the ceiling or on the outside of the canopy after raising the canopy during final installation.
Achten Sie beim Anheben des Gehäuses darauf, dass das Sensorkabel innerhalb der Kerbe an der oberen Kante der Abdeckung verläuft. Falls die
Abdeckung Ihres Ventilators keine Kerbe hat, gehen Sie bei der Anbringung des Gehäuses vorsichtig vor, damit das Sensorkabel nicht durch die
Kerbe der Abdeckung beschädigt wird. Der Sensor sollte entweder an der Decke oder am Lampengehäuse angebracht werden, nachdem das
Gehäuse bei Abschluss der Installierung nach oben geführt wird.
En élevant la garniture, vérifiez que le fil du capteur est positionné dans la fente située au bord de la garniture. Si la garniture n’a pas de fente,
prenez garde en fixant la garniture car le bord de la garniture risque de couper le fil du capteur. Installez le capteur au plafond ou sur le côté extéri-
eur de la garniture après l’avoir soulevée lors de l’installation finale.
Quando si solleva la calotta, sincerarsi che il filo del sensore sia inserito nell'intaglio sul bordo della calotta stessa. Se la calotta non presenta un inta-
glio, prestare attenzione durante la sua installazione poiché il suo bordo tagliente potrebbe recidere il filo del sensore. Montare il sensore sul soffitto
o sull'esterno della calotta dopo aver sollevato quest'ultima durante l'installazione finale.
Let er bij het omhoog brengen van de plafondkap op dat de sensordraad in de uitsparing of inkeping in de bovenrand van de plafondkap komt te
zitten. Als uw plafondkap geen uitsparing of inkeping heeft, moet u voorzichtig zijn bij het bevestigen ervan omdat de rand van de plafondkap de
sensordraad kan doorsnijden. Bevestig de sensor aan het plafond of aan de buitenkant van de kap, die omhooggeschoven moet worden om de
installatie te voltooien.
Al levantar el dosel, asegúrese de que el cable del sensor esté colocado dentro de la muesca recortada en el borde superior del dosel. Si su dosel no
tiene una muesca recortada, tenga cuidado al fijar el dosel porque el borde del dosel podría cortar el cable del sensor. Asegúrese de montar el sen-
sor en el cielo raso o fuera del dosel luego de subir el dosel durante la instalación final.
Quando levantar a campânula, certifique-se que o fio do sensor fica colocado no encaixe recortado na ponta superior da campânula. Se a
campânula não tiver um encaixe recortado, tenha cuidado quando ligar a campânula, uma vez que a extremidade da campânula pode cortar o fio
do sensor. Certifique-se que montou o sensor no tecto fora da campânula depois de levantar a campânula durante a instalação final.
Når canopyenheten heves, sørg for at sensor-ledningen plasseres i det innskjærte hakket i canopyenhetens overkant. Hvis canopyenheten ikke har
et innskjært hakk, må du passe på at ikke sensor-ledningen kuttes av kanten på canopyenheten når den festes. Sørg for å montere sensoren i taket
eller på utsiden av canopyenheten når canopyen er hevet etter ferdig montering.
När du höjer armaturkåpan, se till att sensorledningen placeras i urtaget i kanten på kåpan. Om din armaturkåpa inte har ett urtag måste du vara
försiktig när du fäster kåpan eftersom kanten på kåpan kan skära av sensorledningen. Se till att montera sensorn i taket eller på utsidan av
armaturkåpan efter det att armaturkåpan höjts efter avslutad installation.
Kun nostat kupua, varmista, että anturin johto on asetettu kuvun yläreunassa olevaan loveen. Jos kuvussa ei ole lovea, varo kupua kiinnittäessäsi,
ettei kuvun reuna leikkaa johtoa poikki. Kiinnitä anturi kattoon tai kuvun ulkopintaan, sen jälkeen kun olet nostanut kuvun lopullisen asennuksen
yhteydessä.
Sørg for at sensorledning er placeret i indskæringshullet på øverste kant af skærmen, når skærmen hejses op. Hvis din skærm ikke har et
indskæringshul, sørg for at der passes på, når skærmen monteres, så skærmens kant afskærer ikke sensorledningen. Sørg for at sensor monteres
på loftet eller på ydersiden af dækslet efter hejsning af dækslet på plads under den afsluttende installation.
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Westinghouse Madeline at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Westinghouse Madeline in the language / languages: All languages as an attachment in your email.
The manual is 3,1 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
The manual is sent by email. Check your email
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
