533918
20
Zoom out
Zoom in
Previous page
1/51
Next page
20
Towing hitch Without electrical set
Manufacturer: WESTFALIA-AUTOMOTIVE GmbH Westfalia order no.: 313 174
Approval no. as per Guideline 94/20/EC: e13 00-0834
Class: A50-X Model: 313 164
Technical data: Maximum D-value: 7,4 kN
Maximum nose weight: 75 kg
Area of application: Vehicle manufacturer: Mercedes Benz
Model: Vaneo
Model designation: NCV1
General information:
The vehicle manufacturers specifications regarding trailer load and nose weight are decisive for
driving, and the values specified for the towing hitch must not be exceeded.
The towing hitch serves for towing trailers fitted with ball couplings and for use with load carriers approved
for attachment to the towing hitch. Any use other than that specified is prohibited. Driving with a trailer must
be adapted to the road conditions. The vehicle’s handling is affected when a trailer is being towed. Follow
the vehicle manufacturer’s instructions.
If vehicles are fitted with a Parking Distance Control (PDC) system malfunctioning of the system
can occur after tow bar installation since the parts (ball bar, ball coupling) could be located in the
detection area of the sensors. In this case, the detection area should be readjusted or the PDC
deactivated. Malfunctioning is not expected when using tow bars with detachable or pivoted ball bars if
the ball bar is removed from its operating position.
The fixing points specified as standard must be observed.
National guidelines concerning official approval of auxiliaries must be observed.
These installation and operating instructions must be enclosed with the vehicle papers.
Installation instructions:
The towing hitch is a safety component and must only be installed by qualified personnel.
Any alteration or conversion to the towing hitch is prohibited, and would lead to cancellation of design
certification.
Remove insulating compound and underseal from vehicle (if present) in the area of the mating
surfaces of the towing hitch. Seal any bare bodywork and bores with anti-corrosive paint.
Operating instructions:
Again tighten all securing bolts of the towing hitch after approx. 1000 trailer km, observing specified
tightening torques.
The towing hitch must be kept clean and greased. However, if a stabilisation device, e.g. Westfalia
“SSK”, is used, the towing hitch must be free from grease. Follow the instructions in the relevant
operating instructions.
As soon as the towing hitch diameter is 49.0 mm or less at any point, it must no longer be used for
safety reasons.
After the towing hitch is fitted, the empty weight of the vehicle increases by 16,6 kg.
Subject to alteration.
GB
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Westfalia 313174 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Westfalia 313174 in the language / languages: All languages as an attachment in your email.

The manual is 1,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info