815061

Westbo WeRa Manual

4
Zoom out
Zoom in
Previous page
1/7
Next page
Westbo WeRa Fire advise
Safety
Westbo WeRa is tested according to the DIN standard DIN
13240.
The stove is room air dependent, i.e., the combustion air is
consumed from the installation room. Make sure that an ade-
quate air supply is ensured.
The stove is equipped with a control for supply air to the com-
bustion and is located above the rebox.
Observe the distances to ammable objects. Do not leave
paper, newspapers or other combustible materials near the
stove.
The stove can be hot!
Risk of burns on all surfaces: combustion chamber door, door
and control handles, smoke pipes and the front of the stove.
Do not leave children unattended near the stove.
Empty the ashes
Never drain ash into a combustible vessel, preferably use a
sheet metal vessel with a tight tting lid. There may be ember
residues in the ashes several days after the end of the re.
Smell
At the rst ring, some odors may appear.
It is due to certain coatings on the plate that are burned off.
The smell disappears after a couple of bonres.
First re
We advise you to use ignition pads or equivalent. With
the help of these, there will be a quick over ignition of the
wood and a cleaner combustion.
Never use lighter uid.
At rst ignition, the supply air control shall be fully opened.
Put in about 1-2 kilograms of kindling wood (thin logs).
Put a 2-3 kindling pads on top and light on. Close the
door when the re has started. With this method, there
will be a quick over ignition and it minimizes soot coating
on the glass.
When lling wood, carefully open the door so that smoke
rash is avoided. Never ll up with wood as long as it burns
a lot.
Continuous ring
It is important to get the right temperature in the replace.
Then the stove and wood are utilized to the maximum
and there will be a clean combustion. Soot coating in the
rebox and on the glass is also avoided.
When red correctly, the smoke should not be visible, but
only perceived as a dripping in the air.
In the case of a good ember bed after the ignition pha-
se, the actual ring can begin with the right amount of
rewood.
Now adjust the supply air control relative to the draught
in the chimney. It should burn well, if it is strangled too
much, there is a risk of soot coating in the rebox, as well
as sooting on the glass.
Recommend amount of wood
We recommend smaller wood logs, that can be placed in
the stove. Length of wood is approximately 20 cm and at
the most 3 kg. The maximum amount of wood allowed is
approximately 3 kg per hour for dry cut birch wood.
Sweeping
Sweeping should be done by the Chimney sweeper.
Sweeping of the stove can be done by scraping down
and/or brushing. To collect the ashes, the most suitable
is to use a soot vacuum cleaner.
Chimney re
If a chimney re occurs or is feared, dampers and hatches
must be closed. If necessary, contact emergency services
for extinguishing. After a chimney re, the chimney must
always be inspected.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Westbo WeRa at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Westbo WeRa in the language / languages: English as an attachment in your email.

The manual is 0.88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info