784894
9
Zoom out
Zoom in
Previous page
1/76
Next page
7
7. Connecting the appliance to the pool – see FIG. 7.1. and 7.2.
Use suitable pool hoses and hose clamps to connect the appliance to the pool.
Product operation
1. Pump Watering/venting
Remove the lid off the “ODPAD/WASTE” port (FIG. 8.1), turn the lever of the valve to the VENTING position
and wait until water starts pouring out of the port (FIG. 8.2). Afterwards, switch the valve lever to the CLOSED
position and screw the lid back on. Finally, switch the lever to the FILTERING position. You can now run the
filtering.
Prior to the first use or after a sand filling replacement, you first need to rinse the sand.
2. Start-up
Use the switch at the rear of the filtering equipment to activate the device.
ON FIG. 9.1
OFF FIG. 9.2
Prior to plugging the appliance into the mains, check the valve position!
Never turn the appliance on if the six-way valve is in the CLOSED position or if the
circulation pipeline is impassable.
2.A Azuro equipment with the “T” marking features an adjustable timer (FIG. 9.3):
Use the moving switch to select the required functionality. The timer can be set by 20-minute steps in a 24-
hour cycle. One step corresponds to 20 minutes, which makes 3 steps equal to 1 hour. The LED indicator indicates
the device is running.
3. Operation
Set the valve to the FILTERING position and turn the appliance on. Regularly check the filtering flow-through
(pressure on the pressure gauge) and rinse the sand based on the measured values.
It is advisable to set a filtering schedule corresponding to the size and usage of the pool. Proper filtering is
contingent upon having the water filtered at least once a day. Therefore, the minimum operation time of the
filtering equipment is the volume of the pool divided by the flow-through of the filtering equipment.
Example: When using AZURO 2m3/hr to filter a 10m3 pool, the minimum time would be 5 hours.
4. Prefilter Cleaning
If the prefilter is visibly dirty or the functionality of the filtering equipment is diminished, clean the prefilter
with a stream of water (FIG. 10.1). AZURO 6m³/h + Timer (FIG. 10.2).
5. Backwash Sand
It is possible to tell by the vessel pressure when it’s necessary to rinse the filtering medium. After the first
running with clean filtering sand, make note of the pressure value; if the pressure later rises by more than one
unit on the scale, you need to BACKWASH (23 minutes) + RINSE (about 30 seconds) see Valve Positions”. If
filtering is performed every day, it is recommended to rinse the sand at least once per week.
For the filtering functions such as BACKWASH, RINSE and WASTE, you can use the waste set screw the arbour
(or an elbow with the waste hose arbour) directly onto the “ODPAD/WASTE” port instead of a cap.
WHEN DRAINING WATER FROM THE “ODPAD/WASTE” PORT, MAKE SURE YOU COMPLY WITH ALL LEGAL
REQUIREMENTS FOR WASTE WATER HANDLING. DO NOT LET THE WATER INTO PLACES WHERE IT COULD CAUSE
DAMAGE BY FLOODING. THE “ODPAD/WASTE” PORT CAN BE FITTED WITH WASTE HOSE CONNECTION
THREADING. WHEN FILTERING, THE “ODPAD/WASTE” PORT SHOULD BE CLOSED BY A CAP.
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wellis Sand Filter at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wellis Sand Filter in the language / languages: English, German, French as an attachment in your email.

The manual is 9.73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info